3.3HALTING A SCAN SEQUENCE
To halt a scan sequence, the operator must have selected the monitor running that scan sequence.
When the 
key is pressed, the message:
will be displayed. The last camera selection made by the scan sequence will remain displayed on the monitor.
To restart a previously halted scan sequence, press the 
key followed by the 
key. A number is not required.
•for example, 
.. restarts the last scan sequence halted for this monitor.
If the monitor is already running a scan sequence before manually selecting a camera (or a different scan sequence), then the following message appears:
Rev. A | HMXMU001056 | |
|
| 03/16/05 |