Honeywell MAXPRO-NET manual Selecting AN Alternate Camera

6.4 CAMERA PTZ FLASHBACK, CONTINUED

Press the key to move to the first FLASHBACK position. This is similar to recalling a preset view, although the prior position is first remembered. The dome PTZ can be operated manually as required.

To go back to the prior position, press the key. Now your current position is remembered and the prior position is recalled. The FLASHBACK feature allows two separate targets to be followed using the one high-speed dome camera.

Recalling a preset view will first cause your current position to be remembered as the next FLASHBACK position.

6.5 SELECTING AN ALTERNATE CAMERA

For every camera, it is possible to have a pre-defined alternate camera. Often the alternate camera is a PTZ camera and view recall position, or simply another fixed camera giving a different viewing angle of the same scene.

To display an alternate camera, the following must first be true.

1.You must currently be selecting a monitor,

2.The monitor must be displaying a camera,

3.The camera must have been commissioned with a pre-defined alternate camera selection.

4.You must be using a HEGS5300 enhanced keyboard.

Press the key to select the alternate camera (and view recall position). The monitor should now be displaying the alternate camera. If the message prompt;

was displayed, no alternate camera is available.

Pressing the key again will re-select the original camera.

Rev. A	6-4	HMXMU001056
		03/16/05