Cisco Systems R2001120402, UCS C200 M1 manual Attaching a Slide-Rail Assembly

Chapter 2 Installing the Server

Installing the Server Into a Rack

Figure 2-2 Attaching a Slide-Rail Assembly

1	2
	3
	4

5

6

195968

1	Front-left rack post	4	Length-adjustment bracket
2	Rear-left rack post	5	Locking clip (one on each end of assembly)
3	Slide-rail assembly	6	Mounting pegs (two on each end of assembly)

Note The mounting pegs that protrude through the rack-post holes are designed to fit round or square #12-24 holes, or #10-32 holes when the mounting peg is compressed (see Figure 2-3). If your rack has #10-32 rack-post holes, align the mounting pegs with the holes and then compress the spring-loaded pegs to expose the #10-32 inner peg.

Figure 2-3 Spring-Loaded Mounting Pegs

1

2

330245

1

Pegs in standard (uncompressed) position

2

Pegs compressed to expose 10-32 inner peg

c.Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.

Cisco UCS C200 Server Installation and Service Guide

2-6 OL-20732-02