Cisco Systems R2001120402, UCS C200 M1 manual Removing the Front Cover of the Server

Chapter 3 Maintaining the Server

Preparing for Component Installation

Removing and Replacing the Server Front Cover (Small Form Factor Only)

Note It is not necessary to remove the front cover unless instructed to do so in a replacement procedure.

To remove or replace the front cover of the SFF version of the server (PID UCSC-BSE-SFF-C200), follow these steps:

Step 1 Remove a front cover:

a.Remove the server top cover, as described in Removing and Replacing the Server Top Cover, page 3-9.

b.Use a Number 2 Phillips-head screwdriver to remove the 10 screws that secure the front cover. There are four screws on the upper surface and three screws on each side of the front cover (see Figure 3-5).

c.Lift the front cover straight up off of the chassis.

Step 2 Replace a front cover:

a.Set the front cover back in place, aligning the screw holes in the cover with those in the chassis.

b.Replace the 10 securing screws.

c.Replace the top cover as described in Removing and Replacing the Server Top Cover, page 3-9.

Figure 3-5 Removing the Front Cover of the Server

1

282335

1

Front cover, with 4 screws on the upper surface and 3 screws on each side

	Cisco UCS C200 Server Installation and Service Guide
3-10	OL-20732-02