Delta Electronics manual DeviceNet Network Scanner DVPDNET-SL

Page 14

DeviceNet Network Scanner DVPDNET-SL

(5) Click on “OK”, and DeviceNetBuilder will start to scan the entire network.

(6)If the bar on the dialog box does not progress, it means the connection between the PC and DVP-SV is abnormal, or there are other programs also using the COM port on the PC. After the scan is completed, the dialog box will tell you that the scan is completed, and the icons and device names of all the nodes scanned on the network will be shown on the screen. See the figure below, in which the node address of DVPDNET-SL is 01.

(7) Double click on RTU-DNET (node 02), and the "Node Configuration…” dialog box will appear.

12	DVP-PLC Application Manual

Image 14

Contents DVPDNET-SL Page Table of Contents Display of Node Status in Scan List Status of DVPDNET-SL Digital Indicator LEDPrinciple of Bit-Strobe Features IntroductionI/O Scan List CanDimension Product Profile & OutlineShield DVPDNET-SL PINVDC Canl CanhIN1 Installing DVPDNET-SL and DVP-SV MPU on DIN RailBasic Operation Configuration Corresponding Relation between DVPDNET-SL and DVP-SVI/O Mapping Table How to Construct a DeviceNet NetworkConstructing DeviceNet Network RTU-DNET Ascii COM1DVP-SV DeviceNet Network Scanner DVPDNET-SL DeviceNet Network Scanner DVPDNET-SL DeviceNet Network Scanner DVPDNET-SL DeviceNet Network Scanner DVPDNET-SL DeviceNet Network Scanner DVPDNET-SL DVPDNET-SL Slave → DVPDNET-SL Register Devices in slave PLC program Sending Explicit Message from Ladder Diagram Principle of Explicit Message SendingMAC ID Node Address00 DeviceNet Node Address02 H0101 D6250 ReqID = 01, Command = DeviceNet Network Scanner DVPDNET-SL H0008 D6251 Port = 00, Size = Display of Node Status in Scan List Bit-Strobe CommandDisplay of Node Status on Network PLCLED Indicator & Trouble-shooting Power LEDMS LED NS LED MS LEDCorrection is needed Memo