LG Electronics 1302-REV00, MFL67652408 owner manual 10 mm

Page 9

INSTALLATION 9

9 Adjust the Ez bracket by following the Laser Display screen adjustment steps to make the size of the projection screen equal to that of the paper screen. Position the projection screen, aligning it with the black line of the paper screen.

(If there is a gap larger than 10 mm between the projection screen and the paper screen, mark the screen position on the paper screen and make holes in four places.)

CAUTION

yyWhen adjusting the screen with the paper screen, do not move the Ez bracket to the left or right.

If it is necessary to move the bracket, detach the paper screen first. If you make too many left/right adjustments, further adjustments may be not be possible due to lack of marginal space when actually attaching and using the screen.

Projection screen

10 mm

Paper screen

Image 9
Contents Laser Display install guide Safety Precautions Otherwise, it may cause personal injury Preparations AccessoriesHow to fix anchors and screws InstallationInstallation Procedure Stand Type Installation Center line Paper screen 10 mm Installation Wall Installation Magnet Installation Left side Right side If the screen does not stay level If the screen is not parallel to the wallInstallation Adjust the projection to fit within the screen Ez Bracket Adjustment Guide 1. Reset projectionLength a = Length B To turn the projection clockwise Length a = Length B Enlarge the projection to fit the screen size If the projection is rectangle-shapedOption