16INSTALLATION
If the screen is not parallel to the wall
NOTE
yyIf the top of the screen is tilted to the wall, add space steels at the top and, if the bottom of screen is tilted to the wall, add magnets at the bottom to make the screen parallel to the wall.
If the screen does not stay level
If you want to move the screen vertically or if it does not stay level, remove the screen and adjust the bracket on the back. Loosen the six screws of the bracket to move it and fasten the screws again.
(4 mm of distance between slots = 0.14°) (Hang the screen again following steps
NOTE
yyWhen you fix a bracket screw to a lower hole, the screen goes up. When you fix a bracket screw to a higher hole, the screen goes down.
yyThe left and right bracket assemblies are different as shown below.
Left | Right |