3M 1420EZ manual Read Only Button

Page 11

Read Only Button

When the Read Only button is selected, the Dynatel1420EZ Writer reads all of the iD-Markers that are in the Dynatel1420EZ Stand and then sends the results back to DynatelPCTools.

The written iD-Marker data, if any is present, is then displayed as shown in the following screen shot;

Marker

Data

Markers read without errors

The information from each read marker is displayed in the Marker Data / Status section. The following information is displayed;

The Serial ID column displays the unique serial number of each iD-Marker.

The Model column displays the iD-Marker part number, utility type (frequency) and the iD-Marker type (i.e., Ball, Near Surface or Disk).

78-9000-0120-3-A

11

Image 11
Contents 3M Dynatel 1420EZ Writer Contents Intended Use Safety InformationInitial Set-up Dynatel 1420EZ Stand AssemblyIntroduction Dynatel 1420EZ Writer Keypad, Icon and Port Definitions Dynatel 1420EZ Writer Battery InstallationDynatel 1420EZ Writer Operation Click the Initial Configuration buttonRead/Write Tab Set-up in Dynatel PCTools Creating iD-Marker Templates using Dynatel PCToolsTemplate Section Log Data Section Writing iD-MarkersRead or Read/Write iD-Markers Read Only Button Read and Write Button Was Blank Marker Heading Written and verified Read Failures Error and Warning MessagesLow Battery 78-9000-0120-3-A Read and Write Failures Total Number of Markers in Fixture Error Miscellaneous Errors Dynatel 1420EZ Writer SpecificationsImportant Notice