3M 1420EZ manual Template Section

Page 8

Following is a Read/Write tab screen shot that highlights the different setups that can be configured by the user.

Template

Log Data

Markers in the fixture

To write data to an iD-Marker, the following information must be provided by the user:

Options

Template Section:

−−Select a Template Name from the Templates folder by using the Browse button.

−−The Selected Template section displays the selected template data. This template data will be written into the iD-Marker when the Read and Write button is clicked.

NOTE: The template cannot be edited from this tab. Template editing is accomplished through the “Create/Edit Templates” tab in DynatelPCTools.

Options Section: In Setup Options;

−−Select the desired marker utility (Telephone, Power, Gas, Water, Waste Water, Communication and General Purpose) from the drop down menu.

8

78-9000-0120-3-A

Image 8
Contents 3M Dynatel 1420EZ Writer Contents Safety Information Intended UseInitial Set-up Dynatel 1420EZ Stand AssemblyIntroduction Dynatel 1420EZ Writer Battery Installation Dynatel 1420EZ Writer Keypad, Icon and Port DefinitionsClick the Initial Configuration button Dynatel 1420EZ Writer OperationCreating iD-Marker Templates using Dynatel PCTools Read/Write Tab Set-up in Dynatel PCToolsTemplate Section Writing iD-Markers Log Data SectionRead or Read/Write iD-Markers Read Only Button Read and Write Button Was Blank Marker Heading Written and verified Read Failures Error and Warning MessagesLow Battery 78-9000-0120-3-A Read and Write Failures Total Number of Markers in Fixture Error Miscellaneous Errors Specifications Dynatel 1420EZ WriterImportant Notice