3M 1420EZ manual Safety Information, Intended Use

Page 3

Safety Information

Please read, understand and follow all safety information contained in these instructions prior to the use of the 3MDynatel1420EZ Writer. Retain these instructions for future reference.

Intended Use

The Dynatel1420EZ Writer includes writer/reader and stand to write unique user information into a maximum of ten (10) 3MEMS 1400 Series iD Ball Markers, ten (10) iD Near Surface Markers or ten (10) iD Disk Markers at one time. The system must be installed as specified in the Dynatel1420EZ Writer documentation. It has not been evaluated for other uses or locations.

Explanation of Signal Word Consequences

mCaution: Indicates hazardous situation which if not avoided, could result in minor or moderate injury.

Notice: Indicates a situation which if not avoided, could result in property damage only.

Explanation of Product Safety Label Symbols

Do not throw away in normal trash.

mCaution

To reduce the risks associated with fire and explosion:

Do not short, excessively heat or incinerate the batteries.

To reduce the risks associated with falling/impact due to table break down:

Do not sit on or over load the table.

To reduce the risks associated with environmental contamination:

Dispose of batteries and electronic components in accordance with all regulations.

Notice

To reduce the risks associated with property damage:

If the Permanently Lock Marker Data checkbox in the Setup Options section is selected the following warning dialog box is displayed:

If Yes is selected, the iD-Markers will be permanently locked after being written.

If No is selected, the selection will be removed and the iD-Markers will not be locked after being written.

78-9000-0120-3-A

3

Image 3
Contents 3M Dynatel 1420EZ Writer Contents Intended Use Safety InformationDynatel 1420EZ Stand Assembly IntroductionInitial Set-up Dynatel 1420EZ Writer Keypad, Icon and Port Definitions Dynatel 1420EZ Writer Battery InstallationDynatel 1420EZ Writer Operation Click the Initial Configuration buttonRead/Write Tab Set-up in Dynatel PCTools Creating iD-Marker Templates using Dynatel PCToolsTemplate Section Log Data Section Writing iD-MarkersRead or Read/Write iD-Markers Read Only Button Read and Write Button Was Blank Marker Heading Written and verified Error and Warning Messages Low BatteryRead Failures 78-9000-0120-3-A Read and Write Failures Total Number of Markers in Fixture Error Miscellaneous Errors Dynatel 1420EZ Writer SpecificationsImportant Notice