3M 1420EZ manual Read and Write Button

Page 12

The “Blank” Marker column displays;

−−(check mark) if there is not any previously written data present in the iD-Markers.

−−(warning symbol with a magnifying glass) if previously written data is present in the iD-Markers.

Clicking the magnifying glass opens a new dialog box (shown below) which displays the previously written template data.

The Signal Level column displays the signal level at which the iD-Marker was read.

The Data Errors column displays;

−−A icon is displayed when no reading errors have occurred.

−−An icon is displayed if a read error has occurred.

Either perform the Read Only process again, or

Remove and replace the iD-Marker(s) that indicate an error.

The Lock column indicates the lock status (open or closed lock icon) of the written data.

The Total Markers Read box shows the total of all the iD-Markers that were read without any errors.

−−If this count matches the Enter No. of Markers in Fixtures box value, then it is highlighted in green.

−−If the count does not match, then it is highlighted in red.

Read and Write Button

When the Read and Write button is clicked, all the iD-Markers are first read. If the iD-Markers are read without any errors, then the Dynatel1420EZ Writer proceeds to write to the iD-Markers with the selected template data.

The following dialog box appears indicating that the writing process is in progress;

12

78-9000-0120-3-A

Image 12
Contents 3M Dynatel 1420EZ Writer Contents Safety Information Intended UseDynatel 1420EZ Stand Assembly IntroductionInitial Set-up Dynatel 1420EZ Writer Battery Installation Dynatel 1420EZ Writer Keypad, Icon and Port DefinitionsClick the Initial Configuration button Dynatel 1420EZ Writer OperationCreating iD-Marker Templates using Dynatel PCTools Read/Write Tab Set-up in Dynatel PCToolsTemplate Section Writing iD-Markers Log Data SectionRead or Read/Write iD-Markers Read Only Button Read and Write Button Was Blank Marker Heading Written and verified Error and Warning Messages Low BatteryRead Failures 78-9000-0120-3-A Read and Write Failures Total Number of Markers in Fixture Error Miscellaneous Errors Specifications Dynatel 1420EZ WriterImportant Notice