Actiontec electronic V.90 manual Table of Contents

Page 2

Table of Contents

 

Do This First

3

For Windows 3.1X Installation

3

For Windows 95/98 Installation

4

For Windows NT 4.0 Installation

6

Installing the Modem

7

Jumper Settings

7

Hardware Installation

8

Connecting Devices to the Modem

10

Configuring Windows 95

10

Configuring Windows 95 OEM Service Release 2

11

Configuring Windows 98

11

Configuring Windows NT 4.00

12

Installing and Configuring Communications Software

14

Using the Modem’s Voice Features

14

Troubleshooting

15

Appendix A - AT Commands and S-Registers

20

AT Commands

21

S Registers

28

Appendix B - Communications Regulations

31

Proprietary Notice and Disclaimer

Unless otherwise noted, this document and the information herein disclosed are propri- etary to ActionTec Electronics, Inc. Any person or entity to whom this document is fur- nished or who otherwise has possession thereof, by acceptance agrees that it will not be copied or reproduced in whole or in part, nor used in any manner except to meet the purposes for which it was delivered.

The information in this document is subject to change without notice and should not be construed as a commitment by ActionTec. Although ActionTec will make every effort to inform users of substantive errors, ActionTec disclaims all liability for any loss or damage resulting from the use of this document or any hardware or software described herein, including without limitation contingent, special or incidental liability.

Note: PC is a trademark of IBM Corporation. Windows 3.1, Windows 95, and Windows NT are trademarks of Microsoft, Inc. K56flex is a trademark of Lucent Technologies, Inc. and Rockwell International.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Page Table of Contents For Windows 3.1 Installation Do This FirstFor Windows 95/98 Installation Win95 Modems Properties PanelPage Page Installing The Modem Jumper SettingsHardware Installation JP2 IRQ interrupt request OptionsPage Connecting Devices to the Modem Configuring WindowsConfiguring Windows 95 OEM SR2 Configuring Windows NT Diskette or CD-ROM into the appropriate drive. Click NextPage Full-Duplex Speakerphone Installing and Configuring Communications SoftwareData TIA/EIA-602 Fax TIA/EIA-578 for Class 1 Fax Voice Troubleshooting Check Modem PropertiesModem Diagnostics Page Common Problems No Dialtone Error Page Registers Appendix a AT Command Set+++ATCR To display the value of an S-registerRepeat Last Command On-line Data Character Echo Command Disables echo to the computerEnables echo to the computer default On-line character echo disabled. defaultSpeaker is always on when modem is off-hook Monitor Speaker ModeThis command turns the speaker on or off Speaker is off Return On-line to Data ModeConnect result code reports DTE modem to computer speed Displays result codes as text defaultResult Code Option Connect result code reports DTE speedThis command selects DSR action S0 DSR always on default M0 Modem only supports asynchronous mode.defaultQ0 Modem only supports asynchronous mode Data Set Ready DSR OptionSelect Stored Profile On Power-UP Modulation Selections Escape Character Page Default 50 1 second S25 Detect DTR Change FCC Part 68 Requirements Appendix B Communications RegulationsFCC Regulations Declaration of Conformity Canadian Department of Communications Cdoc Requirements for End Users
Top Page Image Contents