Actiontec electronic V.90 manual Default 50 1 second S25 Detect DTR Change

Page 30

Default: 50 (1 second)

S25

Detect DTR Change

S25 defines the minimum amount of time that DTR has to remain off before the modem performs the function specified by the &Dn command. A change in DTR that persists for a shorter time than that specified will be ignored by the modem.

Range: 1-255 1/100 of a second

Default: 5 (1/20 of a second)

S30

Disconnect Inactivity Timer

This register sets the length of time that the modem stays on-line/off-hook before disconnecting when no data is being sent or received.

Range: 1-255 minutes

Default: 1 minute

S33

Sleep Mode Timer

S33 determines when the modem enters sleep or power-down mode. When en- abled ( any value other than zero), the controller enters sleep mode whenever the modem has been inactive for a user-programmed time delay. The modem exits sleep mode whenever the host computer reads or writes to the modem or when a ring signal is detected.

Range: 0-90 seconds

Default: 0 (disabled)

S37

Maximum Line Speed Attempted

This register sets the maximum line speed allowed. S37 provides the same infor- mation as the AT+MS=m command. Using the +ms=m parameter automatically changes the value of S37. For example, setting AT+MS=0 sets S37 to 0 (zero). Using the AT+MS=m command to change the value of S37 provides greater flex- ibility than changing the S register directly. See the AT+MS=m command for more information.

30

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Page Table of Contents For Windows 3.1 Installation Do This FirstFor Windows 95/98 Installation Win95 Modems Properties PanelPage Page Installing The Modem Jumper SettingsHardware Installation JP2 IRQ interrupt request OptionsPage Connecting Devices to the Modem Configuring WindowsConfiguring Windows 95 OEM SR2 Configuring Windows NT Diskette or CD-ROM into the appropriate drive. Click NextPage Installing and Configuring Communications Software Data TIA/EIA-602 Fax TIA/EIA-578 for Class 1 Fax VoiceFull-Duplex Speakerphone Troubleshooting Check Modem PropertiesModem Diagnostics Page Common Problems No Dialtone Error Page Registers Appendix a AT Command Set+++ATCR To display the value of an S-registerRepeat Last Command On-line Data Character Echo Command Disables echo to the computerEnables echo to the computer default On-line character echo disabled. defaultSpeaker is always on when modem is off-hook Monitor Speaker ModeThis command turns the speaker on or off Speaker is off Return On-line to Data ModeConnect result code reports DTE modem to computer speed Displays result codes as text defaultResult Code Option Connect result code reports DTE speedThis command selects DSR action S0 DSR always on default M0 Modem only supports asynchronous mode.defaultQ0 Modem only supports asynchronous mode Data Set Ready DSR OptionSelect Stored Profile On Power-UP Modulation Selections Escape Character Page Default 50 1 second S25 Detect DTR Change Appendix B Communications Regulations FCC RegulationsFCC Part 68 Requirements Declaration of Conformity Canadian Department of Communications Cdoc Requirements for End Users
Top Page Image Contents