Actiontec electronic V.90 Disables echo to the computer, Enables echo to the computer default

This command controls whether or not the characters entered from your computer keyboard are echoed back to your monitor while the modem is in command mode.

E0:	Disables echo to the computer.
E1:	Enables echo to the computer (default).
Fn	On-line Data Character Echo Command

This command determines if the modem will echo data from the DTE.

F0:	On-line data character echo enabled (NOT SUPPORTED, ERROR).
F1:	On-line character echo disabled. (default)
Hn	Hook Control

This command instructs the modem to go on-hook to disconnect a call, or off- hook to make the phone line busy.

H0:	Modem goes on-hook (default).
H1:	Modem goes off-hook.
In	Request ID Information

This command displays specific product information about the modem.

I0:	Reports product code.
I1:	Reports modem chip firmware version.
I2:	Performs a ROM check and calculates and verifies the checksum dis-
	playing OK or ERROR.
I3:	Reports chipset name.
I4:	Reserved.
I5:	Reserved.
I6	Country code.
I7	Reports board version number.
I8	Reports modem firmware features.
Ln	Monitor Speaker Volume

This command sets speaker volume to low, medium, or high.

L0:	Selects lowest volume.
L1:	Selects low volume.
L2:	Selects medium volume (default).
L3:	Selects high volume.

22