Actiontec electronic V.90 manual Monitor Speaker Mode, Speaker is always on when modem is off-hook

Page 23

Mn

Monitor Speaker Mode

This command turns the speaker on or off.

M0:

The speaker is off.

M1:

The speaker is on until the modem detects the carrier signal (default).

M2:

The speaker is always on when modem is off-hook.

M3:

The speaker is on until the carrier is detected, except while dialing.

On

Return On-line to Data Mode

O0:

Instructs the modem to exit on-line command mode and return to data

 

mode (see AT Escape Sequence, +++).

O1:

This command issues a retrain before returning to on-line data mode.

O3:

This command issues a rate renegotiation before returning to on-line

 

data mode.

PSelect Pulse Dialing

This command configures the modem for pulse (non-touch-tone) dialing. Dialed digits are pulsed until a T command or dial modifier is received. Tone dial is the default setting.

Qn

Result Code Control

Result codes are informational messages sent from the modem and displayed on your monitor. Basic result codes are OK, CONNECT, RING, NO CARRIER, and ERROR. The ATQ command allows the user to turn result codes on or off.

Q0:

Enables modem to send result codes to the computer (default).

Q1:

Disables modem from sending result codes to the computer.

TSelect Tone Dialing

This command instructs the modem to send DTMF tones while dialing. Dialed digits are tone dialed until a P command or dial modifier is received. This is the default setting.

Vn

DCE Response Format

This command controls whether result codes (including call progress and negotia- tion progress messages) are displayed as words or their numeric equivalents.

V0:

Displays results as numbers.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Page Table of Contents Do This First For Windows 3.1 InstallationWin95 Modems Properties Panel For Windows 95/98 InstallationPage Page Jumper Settings Installing The ModemJP2 IRQ interrupt request Options Hardware InstallationPage Configuring Windows Connecting Devices to the ModemConfiguring Windows 95 OEM SR2 Diskette or CD-ROM into the appropriate drive. Click Next Configuring Windows NTPage Full-Duplex Speakerphone Installing and Configuring Communications SoftwareData TIA/EIA-602 Fax TIA/EIA-578 for Class 1 Fax Voice Check Modem Properties TroubleshootingModem Diagnostics Page Common Problems No Dialtone Error Page To display the value of an S-register Appendix a AT Command Set+++ATCR RegistersRepeat Last Command On-line character echo disabled. default Disables echo to the computerEnables echo to the computer default On-line Data Character Echo CommandReturn On-line to Data Mode Monitor Speaker ModeThis command turns the speaker on or off Speaker is off Speaker is always on when modem is off-hookConnect result code reports DTE speed Displays result codes as text defaultResult Code Option Connect result code reports DTE modem to computer speedData Set Ready DSR Option M0 Modem only supports asynchronous mode.defaultQ0 Modem only supports asynchronous mode This command selects DSR action S0 DSR always on defaultSelect Stored Profile On Power-UP Modulation Selections Escape Character Page Default 50 1 second S25 Detect DTR Change FCC Part 68 Requirements Appendix B Communications RegulationsFCC Regulations Declaration of Conformity Requirements for End Users Canadian Department of Communications Cdoc
Top Page Image Contents