Actiontec electronic V.90 manual M0 Modem only supports asynchronous mode.default

Page 25

&F

Load Factory Settings

This command loads the configuration stored and programmed at the factory. This operation replaces all of the command options and the S-register settings in the active configuration with factory values.

&F: Recall factory setting as active configuration. (default)

&Gn

V.22bis Guard Tone Control

This command determines which guard tone, if any, to transmit while transmitting in the high band (answer mode). This command is only used in V.22 and V.22bis mode.

&G0: Guard tone disabled (default).

&G1: Sets guard tone to 550 Hz.

&G2: Sets guard tone to 1800 Hz.

&Kn

Serial Port Flow Control Selection

&K0: Disable flow control.

&K3: Enable RTS/CTS flow control (default).

&K4: Enable XON/XOFF flow control.

&Mn

Asynchronous Communications Mode

&M0: Modem only supports asynchronous mode.(default)

&Pn

Pulse Dial Make-to-Break Ratio Selection

This Command sets pulse-dial make-break ratio.

&P0 39%/61% make/break ratio, 10PPS

&PI 33%/67% make/break ratio, 10PPS (default)

&Qn

Asynchronous Communications Mode

&Q0: Modem only supports asynchronous mode.

&Sn

Data Set Ready (DSR) Option

This command selects DSR action.

&S0: DSR always ON (default).

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Page Table of Contents Do This First For Windows 3.1 InstallationWin95 Modems Properties Panel For Windows 95/98 InstallationPage Page Jumper Settings Installing The ModemJP2 IRQ interrupt request Options Hardware InstallationPage Configuring Windows Connecting Devices to the ModemConfiguring Windows 95 OEM SR2 Diskette or CD-ROM into the appropriate drive. Click Next Configuring Windows NTPage Data TIA/EIA-602 Fax TIA/EIA-578 for Class 1 Fax Voice Installing and Configuring Communications SoftwareFull-Duplex Speakerphone Check Modem Properties TroubleshootingModem Diagnostics Page Common Problems No Dialtone Error Page +++ATCR Appendix a AT Command SetRegisters To display the value of an S-registerRepeat Last Command Enables echo to the computer default Disables echo to the computerOn-line Data Character Echo Command On-line character echo disabled. defaultThis command turns the speaker on or off Speaker is off Monitor Speaker ModeSpeaker is always on when modem is off-hook Return On-line to Data ModeResult Code Option Displays result codes as text defaultConnect result code reports DTE modem to computer speed Connect result code reports DTE speedQ0 Modem only supports asynchronous mode M0 Modem only supports asynchronous mode.defaultThis command selects DSR action S0 DSR always on default Data Set Ready DSR OptionSelect Stored Profile On Power-UP Modulation Selections Escape Character Page Default 50 1 second S25 Detect DTR Change FCC Regulations Appendix B Communications RegulationsFCC Part 68 Requirements Declaration of Conformity Requirements for End Users Canadian Department of Communications Cdoc
Top Page Image Contents