Actiontec electronic V.90 manual Appendix B Communications Regulations, FCC Regulations

Page 31

Appendix B: Communications Regulations

FCC REGULATIONS

The following statements are provided in accordance with the Federal Communi- cations Commission (FCC) regulations. Please read these statements carefully before installing your modem.

FCC PART 68 REQUIREMENTS

This equipment complies with Part 68 of the FCC Rules. On the bottom of this equipment is a label that contains, among other information, the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment. If requested, this information must be given to the telephone company.

The REN is used to determine the maximum number of devices connected to your telephone line that will ring in response to an incoming call. In most, but not all, areas, the total REN of devices connected to a line should not exceed five (5.0). To find out the total permitted in your area, contact your local telephone company.

If your telephone equipment causes harm to the telephone network, the telephone company can discontinue your service temporarily. If possible, the company will notify you in advance. But if advance notice isn’t practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.

Your telephone company can make changes in its facilities, equipment, opera- tions, or procedures that could affect the operation of your equipment. If so, you will be notified in advance so you can make the changes needed to maintain unin- terrupted service.

If you experience trouble with this equipment, please contact the manufacturer at the address given in this manual. The telephone company may ask that you dis- connect this equipment from the network until the problem has been corrected or until you are sure that the equipment in is not malfunctioning.

31

Image 31
Contents Page Table of Contents Do This First For Windows 3.1 InstallationWin95 Modems Properties Panel For Windows 95/98 InstallationPage Page Jumper Settings Installing The ModemJP2 IRQ interrupt request Options Hardware InstallationPage Configuring Windows Connecting Devices to the ModemConfiguring Windows 95 OEM SR2 Diskette or CD-ROM into the appropriate drive. Click Next Configuring Windows NTPage Data TIA/EIA-602 Fax TIA/EIA-578 for Class 1 Fax Voice Installing and Configuring Communications SoftwareFull-Duplex Speakerphone Check Modem Properties TroubleshootingModem Diagnostics Page Common Problems No Dialtone Error Page To display the value of an S-register Appendix a AT Command Set+++ATCR RegistersRepeat Last Command On-line character echo disabled. default Disables echo to the computerEnables echo to the computer default On-line Data Character Echo CommandReturn On-line to Data Mode Monitor Speaker ModeThis command turns the speaker on or off Speaker is off Speaker is always on when modem is off-hookConnect result code reports DTE speed Displays result codes as text defaultResult Code Option Connect result code reports DTE modem to computer speedData Set Ready DSR Option M0 Modem only supports asynchronous mode.defaultQ0 Modem only supports asynchronous mode This command selects DSR action S0 DSR always on defaultSelect Stored Profile On Power-UP Modulation Selections Escape Character Page Default 50 1 second S25 Detect DTR Change FCC Regulations Appendix B Communications RegulationsFCC Part 68 Requirements Declaration of Conformity Requirements for End Users Canadian Department of Communications Cdoc