Actiontec electronic V.90 manual JP2 IRQ interrupt request Options, Hardware Installation

Page 8

Jumper Block JP2 is used to select the IRQ (interrupt request) settings for the modem. Figure 4: below details the possible selections.

Figure 4: JP2 IRQ (interrupt request) Options

HARDWARE INSTALLATION

1.Turn off the computer and all peripheral devices connected to it.

2.Unplug the computer power cord from the wall receptacle.

3.Remove the computer’s cover. Refer to your computer owner’s manual for instructions.

4.Remove the screw securing the expansion slot cover behind one of the computer’s available 16-bit ISA expansion slots. Lift the expansion slot cover out as shown below.

Figure 5: Removing the Backplate

8

Image 8
Contents Page Table of Contents For Windows 3.1 Installation Do This FirstFor Windows 95/98 Installation Win95 Modems Properties PanelPage Page Installing The Modem Jumper SettingsHardware Installation JP2 IRQ interrupt request OptionsPage Connecting Devices to the Modem Configuring WindowsConfiguring Windows 95 OEM SR2 Configuring Windows NT Diskette or CD-ROM into the appropriate drive. Click NextPage Full-Duplex Speakerphone Installing and Configuring Communications SoftwareData TIA/EIA-602 Fax TIA/EIA-578 for Class 1 Fax Voice Troubleshooting Check Modem PropertiesModem Diagnostics Page Common Problems No Dialtone Error Page Appendix a AT Command Set +++ATCRRegisters To display the value of an S-registerRepeat Last Command Disables echo to the computer Enables echo to the computer defaultOn-line Data Character Echo Command On-line character echo disabled. defaultMonitor Speaker Mode This command turns the speaker on or off Speaker is offSpeaker is always on when modem is off-hook Return On-line to Data ModeDisplays result codes as text default Result Code OptionConnect result code reports DTE modem to computer speed Connect result code reports DTE speedM0 Modem only supports asynchronous mode.default Q0 Modem only supports asynchronous modeThis command selects DSR action S0 DSR always on default Data Set Ready DSR OptionSelect Stored Profile On Power-UP Modulation Selections Escape Character Page Default 50 1 second S25 Detect DTR Change FCC Part 68 Requirements Appendix B Communications RegulationsFCC Regulations Declaration of Conformity Canadian Department of Communications Cdoc Requirements for End Users