Allied Telesis AT-CV5000 manual Powering On an AC Powered Chassis, Vac ~

Chapter 2: Installation

Powering On an AC Powered Chassis

This section describes how to power on an AC powered AT-CV5000 chassis. If your chassis is DC powered, see “Powering On a DC Powered Chassis” on page 64.

Note

The AT-CV5000 chassis is shipped without any power supplies installed. You must install at least one power supply in order to power on the chassis. For information about installing an AC power supply, refer to “Installing an AT-PWR14 AC Power Supply” on page 82.

Caution

The AT-CV5000 Media Converter chassis can contain two power supplies of the same type (AC or DC) or a combination of the two versions with the same power ratings. Make sure not to mix power supplies with different power ratings in the same chassis.

For information on the power supply module, refer to the documentation that is shipped with the module.

Note

The AT-PWR14 AC power supply is shipped with four power cords, one each for North America, the UK, Europe, and Australia. Locate the correct power cord for your location before beginning this procedure.

To power on an AC powered chassis, perform the following procedure:

1.Make sure that the ON/OFF power switch is in the OFF position, as shown in Figure 36.

A CVFAN-AT

	A
100-240	VAC~
	inrWARNINGTehpdisuutcusenbtitehfmeorirgieshksteohrvfaveiceleinmcgtoruircensitthh. oacnko, ndeispcoownneercint paulltp. Toower
	WER	AT-	PWR14
	PO
	FAULT

277

PWR A

		B
AT-	PWR1	100-	240VAC~	B
POWER		4
FAULT				AT-CV5FAN
			1131

PWR B

Figure 36. ON/OFF Power Switch in OFF Position

60