Allied Telesis AT-CV5000 manual 8mm ±1mm 31in. ±0.039in

AT-CV5000 Media Converter Chassis Installation Guide

4.With a 14-gauge wire-stripping tool, strip the three wires in the tray cable coming from the DC input power source to 8mm ± 1mm (0.31 in.,

± 0.039 in.), as shown in Figure 42 on page 65.

Warning

Do not strip more than the recommended amount of wire. Stripping more than the recommended amount can create a safety hazard by leaving exposed wire on the terminal block after installation.  E10

8mm ±1mm

(0.31in. ±0.039in.)

Figure 42. Stripped Wire

5.Connect the power supply ground wire into the middle of the three terminals; this is the terminal marked with the ground symbol. Inserting the wire into the terminal and tightening the connection with a flathead screwdriver, as shown in Figure 43.

Warning

When installing this equipment, always ensure that the power supply ground connection is installed first and disconnected last.  E11

REAR EXP. SLOT

A A

CVFAN-AT		WARNING	FOR CENTRALIZED DC POWER
		AT-PWR15
	40-60VDC	This unit might have more than one power input. To	CONNECTION, INSTALL ONLY IN
		reduce the risk of electric shock, disconnect all power	A RESTRICTED AREA.
		POWER
		FAULT

PWR A

		G		more	t
	ARNIN ight have			tric s
	W	unit m	of elec
	This	the risk
	reduce
40-6			-P
		AT
POWE	R
FAULT

B

WARNING	FOR CENTRALIZED DC POWER
This unit might have more than one power input. To	CONNECTION, INSTALL ONLY IN	40-60VDC
reduce the risk of electric shock, disconnect all power	A RESTRICTED AREA.

AT-PWR15

POWER

FAULT

B

AT-CVFAN

1124

65