Allied Telesis AT-CV5000 manual Replacing an

Chapter 3: Working with Line Cards and other Modules

Note

This CPU RESET resets only the management card, and does not reset the line cards and/or the module installed in the expansion slot at the rear of the chassis. You may need to reset the management card after upgrading the firmware or after you have made a configuration change that requires resetting the module to implement the change.

2.Press the reset button with the tip of a pen or a non-conductive pointed object, as shown in Figure 52.

Replacing an

AT-CV5M01

Management

Card

AT-
CV5M01
PWR
RDY	FLT

LK AT FD

CPU RESET

519

Figure 52. Resetting the AT-CV5M01 Management Card

When an AT-CV5M01 Management Card is replaced, all the parameter settings saved on the management card are lost. To keep the current parameter settings, upload the configuration file onto a TFTP server before replacing the AT-CV5M01 Management Card. After a new AT-CV5M01 Management Card is installed, you can download the configuration file onto the new management card.

For instructions on how to upload and download a configuration file, refer to Chapter 10, “File Downloads and Uploads” in the AT-S70 Software Management User’s Guide.

78