Franklin U600 manual Auto Connect when device is available, Connection Type

Make a selection in the Roam Guard drop-down list box to specify whether you would like Sprint SmartView to display a warning message when you are about to connect to a roaming network for which there may be additional roaming charges.

●When Always Ask is selected, Sprint SmartView will always display the warning message when connecting to a roaming network.

●When Never Ask is selected, Sprint SmartView will never display the warning message.

Auto Connect when device is available

Select this check box if you want a connection to be automatically established each time you connect your device to your computer. The feature behaves slightly differently when RAS is selected (below) than it does when NDIS is selected. (See “Automatic Connection Upon Device Attachment” on page 25 for more information on the device-based autoconnect feature.)

Note: This check box is available only if the Allow Simultaneous Connections check box on the Hardware settings tab is selected.

Connection Type

This group determines which software interface Sprint SmartView should use to communicate with your device.

●NDIS allows more efficient communication with devices that support it.

●RAS is supported by more devices.

Note: Many devices support only one of these interfaces. If this is the case with your device, the interface that your device supports will be selected by default and you will not be able to change the selection.

94 Sprint SmartView Settings