Savin C3828 Placing Originals in the Auto Document Feeder, Batch, Limit mark Document guide

Placing Originals

Placing Originals in the Auto Document Feeder

Settings should be made accordingly in the following situations:

❖When placing originals consisting of more than 80 pages:

p.15 “Batch”

❖When placing originals one by one: p.16 “SADF”

❖When placing originals of the same width but different sizes:

p.17 “Placing originals of mixed sizes”

❖When placing custom size originals: p.17 “Placing custom size origi- nals”

Note

❒Do not stack originals above the limit mark on the side guide of the ADF.

❒The last page should be on the bot- tom.

❒Do not place objects on the sensors or cover them with your hands, or the original size may not be detect- ed properly. Also, do not place any- thing on the exposure glass cover as this could cause a malfunction.

A Set the document guide to the original size.

B Place the aligned originals face

up into the ADF. 1

1.Limit mark

2.Document guide

Note

❒Straighten any curls in the orig- inals before placing them in the ADF.

❒To prevent multiple sheets from being fed at once, fan the origi- nals before placing them in the ADF.

❒Place the originals squarely.

Batch

The Batch mode enables you to copy originals of more than 80 pages as a single document, even if you place the originals into the ADF in install- ments.

Important

❒Place special originals, such as translucent paper, one by one.

1.Sensors

15