Savin LD238c, LD232c, c3224, DSc332, DSc338, C3828 operating instructions Input/Output

User Tools (Copier/Document Server Features)

Input/Output

❖Switch to Batch (SADF)

You can select to have the Batch or SADF function displayed when you press [Special Original]. See p.15 “Batch”.

Note

❒ Default: Batch

❖SADF Auto Reset

In SADF mode, an original must be set within a specified time after the

	previous original has been fed.
	You can adjust this time from 3 sec-
	onds to 99 in 1 second increments.
5
	Note

❒Default: 5 seconds

❖Rotate Sort: Auto Paper Continue

You can continue copying when paper of the required orientation has run out during rotate-sorting. See p.43 “Rotate Sort”.

Note

❒If you select [No] :

•When paper of the required orientation runs out, the ma- chine stops copying and prompts you to supply copy paper. When you load paper, the machine will continue copying.

❒If you select [Yes] :

❖Auto Sort

You can specify whether the Sort function is to be selected when the machine is turned on, or when the functions are cleared.

Note

❒Default: No

❖Memory Full Auto Scan Restart

If memory becomes full while scanning originals, the machine will copy the scanned originals first, and then automatically pro- ceed scanning remaining originals. You can enable or disable this function.

Note

❒If you select [No] :

•When memory becomes full, the machine stops operation, allowing you to remove the copies on the output tray.

❒If you select [Yes] :

•You can leave the machine unattended to make copies, but sorted pages will not be sequential.

❒Default: No

❖Select Stack Function

Specify whether Stack or Rotate Sort has priority on the initial dis- play.

Note

❒Default: Stack

•Copying continues using copy paper of a different ori- entation. The copy job will finish even if the machine is left unattended.

❒Default: No

❒An 2 tray finisher or booklet fin- isher is required to use this function.

124