Savin DSc332, LD238c, LD232c, c3224, C3828 If You Cannot Make Clear Copies, Problem Causes Solutions

If You Cannot Make Clear Copies

If You Cannot Make Clear Copies

Problem	Causes	Solutions
Copies appear dirty.	The image density is too	Adjust the image density. See p.33
	dark.	“Adjusting Copy Image Density”.
	Auto Image Density is not	Select Auto Image Density. See p.33
	selected.	“Adjusting Copy Image Density”.
The reverse side of an orig-	The image density is too	Adjust the image density. See p.33
inal image is copied.	dark.	“Adjusting Copy Image Density”.
	Auto Image Density is not	Select Auto Image Density. See p.33
	selected.	“Adjusting Copy Image Density”.
A shadow appears on cop-	The image density is too	Adjust the image density. See p.33
ies if you use pasted origi-	dark.	“Adjusting Copy Image Density”.
nals.		Change the orientation of the origi-
		nal.
		Put tape over pasted parts.
The same copy area is dirty	The exposure glass or ADF	Clean them. See “Maintaining Your
whenever making copies.	is dirty.	Machine” General Settings Guide.
Copies are too light.	The image density is too	Adjust the image density. See p.33
	light.	“Adjusting Copy Image Density”.
	The paper size is not suit-	Use a recommended paper size.
	able.	Note
		❒ A light copy may result when
		you use damp or rough grain pa-
		per.
	The toner cartridge is al-	Add toner. See “Adding Toner”
	most empty.	General Settings Guide.
Parts of the image are not	The original is not set cor-	Place originals correctly. See p.13
copied.	rectly.	“Placing Originals”.
	An irregular paper size is	Select a proper paper size.
	selected.
Copies are blank.	The original is not placed	When using the exposure glass,
	correctly.	place originals face down. When us-
		ing the ADF, place them face up. See
		p.13 “Placing Originals”.
A moiré pattern is pro-	Original has a dot pattern	Position the original on the expo-
duced on copies.	image, or too many lines.	sure glass at a slight angle.

R

4

97