
6. ROUTINE OPERATION
6-4 Replacing the Thermal Paper
1.Press the release button, and open the top cover.
See Figure 4.
J
Figure 4
2.Take out the empty roll and install a new one with the leading edge at the top of the roll and facing the rear of the machine.
See Figure 5.
Figure 5
3.Pull out the leading edge about 15 cm [6 inch] and insert it under the guide plate (which is labeled in green) to the rear of the platen roller.
See Figure 6.
klgure b
4.Close the top cover.
A paper cycle is made automatically.
NOTE
If there is no paper cycle, check that the roll is installed correctly.
Nl(mm”
20