Samsung Version 1.1 owner manual Connecting to PAN/TILT/ZOOM/FOCUS Controller

Connecting to PAN/TILT/ZOOM/FOCUS Controller

	RX-
P/T/Z/F Controller 1	RX+
		ALARM IN R/O RX TX
	RX-
P/T/Z/F Controller 2	RX+	1 2 G	3 4 G RA RC - + - +
	RX-
P/T/Z/F Controller 3	RX+
	RX-
P/T/Z/F Controller 4	RX+

The RX/TX terminal of the reverse side of the SNS-110 uses the RS-442/485 interface and PAN/TILT/ZOOM/FOCUS controllers can be connected to the terminal.

The PAN/TILT/ZOOM/FOCUS controllers that are supported are the following.

●Samsung Smart-Dome Camera (SCC-641) ● Pelco : Pelco-P Protocol Support Control

●Sungjin Electronic Communications : CPU-Receiver

Note	When connecting Samsung Smart-Dome Camera (SCC-641), you have to connect the
	SNS-110 to the TxDt, - terminals of SCC-641. In this case, the supportable Baud Rate
	is 38400 and 19200bps. For more detail information, please refer to the user manual
	of SCC-641.
	Reference inquire the shop at which it was purchased for the products other
	that the above PAN/TILT/ZOOM/FOCUS camera and controllers.

The TX+ and TX- of the terminal as shown in picture, is connected to the external terminal of the PAN/TILT/ZOOM/FOCUS controller, and generally the external terminal has a +,- polarity indication so be sure not to switch the polarity.

Set the F/H Switch to On (knob faced down) on the front side of the SNS-110.

Refer to the PAN/TILT/ZOOM/FOCUS controller manual and confirm & reset the following items.

● Baud Rate	● Data Bit
● Stop Bit	● Parity Bit

●Controller ID (be careful not to duplicate a different controller ID)

Caution If several PAN/TILT/ZOOM/FOCUS controllers are used, they must be the same models.

19