Samsung Version 1.1 owner manual Regulation Approval

Page 3

Regulation Approval

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interface in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient of relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio TV technician for help.

3

Image 3

Contents WEB Before You Begin Regulation Approval Table of Contents Administration Mode Functions and Features SNS-110 OverviewOverview Page Front View of SNS-110 Names and FunctionRear of SNS-110 Setting Configuration Installing SNS-110Page 15Cm Surface, due to potential damage on the surface Unpacking VTR, DVDP, TV OUT Connecting to InstrumentsVideo Connecting to External InstrumentsEthernet10BaseT/100BaseT Connecting to NetworkG 3 4 G RA RC + + Connecting to Alarm Sensors and External DevicesThat the above PAN/TILT/ZOOM/FOCUS camera and controllers Connecting to PAN/TILT/ZOOM/FOCUS ControllerRS 232C Terminal D-Sub 9Pin RS 232C Connecting to Cable Connecting to RS-232CTerminal Emulation Communication Set-up Creating RS-232C CableConnected from SNS-110 to PCTwisted Cable Creating Ethernet CableBefore You Begin Setting an IP AddressFor Windows 95/98/ME/NT/2000/XP Setting In Ethernet 10BaseT/100BaseTSetting up IP address in Ethernet Setting in Unix Setting up an IP address in Ethernet Setting with IP Installer Window Page Page Changing IP Address Setting Other Network InformationCable Network through Cable Modem Ideal Specification SNS-110Log-inLog-in through Netscape First Time Log-in through ExplorerPage After the First Time Others Application Mode Video Image Monitoring Mode Initial ScreenSingle Screen Automatic Sequential Screen Quadruplex ScreenSingle Screen with PAN/TILT/ZOOM Controller Administration Mode Camera Set-up PAN/TILT/ZOOM Supported, contact your vendor PAN/TILT/ZOOM Set-upRecommend Quad/Sequential Set-upWeb Transmitter Set-up Password Right after the S/W upgrade, ‘Software Reset’ doesn’t work Recommend Setting the Alarm / Relay OutEnable Network Set-up Between 0~ Page File Transfer Setting Page Custom User Interface Setup ABOUT/ SUPPORT/ Help Page WEB Appendix a SNS-110 Specifications Performance Outside view WEB B Appendix B Factory Default How to Enter the Factory DefaultValues for setting up SNS-110 Dhcp WEB C Appendix C How to Use Console Starting ConsoleMessage Internet Video Server webTX SNS-110 Command Page 5reset SNS-110 »Reset ‰ˆ¯·ˇ· Manual Configuration Mode Page Page Automatically changed to 0. Confirm for more accurate setup WEB D Appendix D Dynamic IP Information Transfer To send IP information to the administrator E-mailSelect items? IP notify-mail enable? Y Registering IP information with Administration server Page Page CGI Program for the Administration Server Setting with the Web BrowserWEB E When e-mails are not sent and alarm sets off Appendix E FAQPage When normally-functioning SNS-110 is suddenly not connecting You cannot use FTP for transfer when setting up FTP transfer E C T R O N I C S