Samsung ML-3050 manual Maintenance parts, Clearing the Toner Low Replace Toner message

Page 40

3Remove the new toner cartridge from its bag.

Caution

Do not use sharp objects, such as a knife or scissors, to open the toner cartridge package. They might scratch the drum of the cartridge.

4Remove the packing tape and roll the cartridge 5 or 6 items to distribute the toner.

Thoroughly roll the cartridge to assure maximum copies per cartridge. Save the box and the plastic bag for shipping.

Cautions

• If toner gets on your clothing, wipe it off with a dry cloth and wash clothing in cold water. Hot water sets toner into fabric.

To prevent damage to the toner cartridge, do not expose it to light for more than a few minutes. Cover it with a piece of paper, if necessary.

Do not touch the green surface underside of the toner cartridge. Use the handle on the cartridge to avoid touching this area.

5Hold the toner cartridge by the handle and slowly insert the cartridge into the opening in the printer.

6Tabs on the sides of the cartridge and corresponding grooves within the printer will guide the cartridge into the correct position until it locks into place completely.

Clearing the Toner Low Replace Toner message

When the Toner Low Replace Toner message appears you can configure not to see this message again not to disturb you.

1Press Menu until System Setup appears on the bottom line of the display and press OK.

2Press the Scroll buttons until Maintenance appears and press OK.

3Press the Scroll buttons until CLR Empty Msg. appears and press OK.

4Select On and press OK.

5Now the Toner Low Replace Toner message does not appear but the Replace Toner message will remain for reminding you that the new cartridge needs to be installed for quality.

Caution

Once you have selected On, this setting will be permanently written to the memory of the toner cartridge, and this menu will be disappeared from the Maintenance menu.

Maintenance parts

To avoid print quality and paper feed problems resulting from worn parts and to maintain your printer in top working condition the following items will need to be replaced at the specified number of pages or when the life span of each item has expired.

Items

Yield (Average)

 

 

Transfer roller

70,000

 

 

Pick-up roller

150,000

 

 

Fuser unit

80,000

 

 

Samsung highly recommends that an authorized service provider, dealer or the retailer where you bought printer performs this maintenance activity.

7Close the front cover. Make sure that the cover is securely closed.

8.4 <Maintenance>

Image 40
Contents Page Page Contact Samsung World Wide Country Customer Care Center Web SiteContents Maintenance TroubleshootingInstalling accessories SpecificationsImportant Precautions and Safety Information FCC Statement for Wireless LAN use FCC RegulationsCanadian Radio Interference Regulations Federal Communications Commission FCCWireless Guidance European States qualified under wireless approvalsEuropean States with restrictions on use Replacing the Fitted Plug for UK Only Special features Special features Printer overview Finding more informationIntroduction You can print in Windows 95/98/Me/NT 4.0/2000/XP/2003Printer overview Features ML-3050 ML-3051N ML-3051NDFront view Rear view Control panel overview ML-3051N and ML-3051NDSelecting a location Finding more informationClearance space System setup Using control panel menus ML-3051N,ML-3051NDonlyAccessing control panel menus Menu overviewInformation menu Layout menuPaper menu Graphic menuSystem Setup menu Emulation menuPostScript Printing a demo Changing the display language ML-3051N,MLNetwork menu ML-3050, ML-3051NUsing the control panel button Using toner save modeFrom the software application Software overview Supplied softwarePrinter driver features FeatureSystem requirements WindowsMacintosh LinuxRequirements Network setup Configuring TCP/IPVia network administration programs Supported operating systemsConfiguring EtherTalk Configuring IPX frame typesDynamic addressing BOOTP/DHCP Static addressingRestoring the network configuration Setting Ethernet speedPrinting a network configuration Loading print media Selecting print mediaType Size Dimensions Weighta Capacityb Supported sizes of paperGuidelines for special print media Guidelines for selecting and storing print mediaMedia type Guidelines Loading paper Using the tray 1 or the optional tray Changing the size of the paper in the trayUsing the multi-purpose tray Load the paper with the side to be printed on facing upUsing manual feed mode Tips on using the multi-purpose trayPrinting to the output tray Face down Selecting an output locationPrinting to the rear cover Face up Canceling a print job Printing a document Canceling a print jobBasic printing Printing a documentHow to purchase Accessories Ordering supplies and accessoriesToner cartridges Maintenance Cleaning the printerCleaning the outside of the printer Cleaning the inside of the printerMaintaining the toner cartridge Checking the remaining tonerRedistributing toner cartridge Replacing the toner cartridgeToner Low appears on the display. ML-3051N,ML-3051ND only Open the front cover Pull the toner cartridge outClearing the Toner Low Replace Toner message Maintenance partsItems Yield Average Troubleshooting Clearing paper jamsPaper feed area TrayOptional tray Multi-purpose trayAround the toner cartridge Paper exit areaDuplex unit area ML-3051NDonly Duplex jamTips for avoiding paper jams Troubleshooting checklist Condition Suggested solutionsUnderstanding the Status LED Status DescriptionUnderstanding display messages Toner cartridge-related messages Solving general printing problems Settings and Printers. Right Spool Settings buttonClick the Samsung ML-3050 Series PCL 6 printer iconSolving print quality problems Condition Suggested solutions Back ScatterMisformed CharactersCommon Windows problems Common PostScript problemsCommon Linux problems Common Macintosh problemsInstalling accessories Precautions when installing accessoriesInstalling a memory Dimm Disconnect the power cordSetting the memory in the PostScript printer properties Installing a wireless network interface cardSelect the Samsung ML-3050 Series PS printer Configuring the wireless network parameters Configuring basic network settingsSetting Encryption Selecting the authentication typeHexadecimal Alphanumeric Specifications Printer specificationsPrinter specifications Specifications and DescriptionIndex System requirements Linux 3.3 Macintosh 3.3 Windows Software section Contents Using Windows Postscript Driver Using Your Printer with a Macintosh Installing Printer Software Installing Software for Local PrintingTypical Installation Select Typical installation for a local printer. Click NextCustom Installation Select Custom installation. Click Next Installing Software for Network Printing Custom Installation Installing Printer Software in Windows Reinstalling Printer Software Changing the Software LanguageRemoving Printer Software NextPrinting a Document Select your printer driver from the Name drop-down listLayout Tab Printer SettingsPaper Orientation Source Paper TabScaling Printing Image Mode ResolutionToner Save Mode Graphics TabAbout Tab Extras TabPrinter Tab Using a Favorite Setting Using HelpAdvanced Printing Printing Multiple Pages on One Sheet of Paper N-Up PrintingPrinting Posters Printing BookletsPrinting on Both Sides of Paper Printing a Reduced or Enlarged DocumentFitting Your Document to a Selected Paper Size NoneUsing Watermarks Using an Existing WatermarkCreating a Watermark Editing a WatermarkUsing Overlays What is an Overlay?Using a Page Overlay Creating a New Page OverlayUsing Windows PostScript Driver AdvancedSetting Up a Host Computer Setting Up a Client ComputerCheck the Share this printer box Select Local Port and click New PortTroubleshooting Guide Printer SettingUnderstanding Smart Panel Toner LevelOpening the Troubleshooting Guide Using Printer Settings UtilityChanging the Smart Panel Program Settings Using Onscreen Help FileInstalling the Unified Linux Driver Installing the Unified Linux DriverGetting Started Using the Unified Driver Configurator Uninstalling the Unified Linux DriverOpening the Unified Driver Configurator Click UninstallPrinters Configuration Ports ConfigurationPrinters Tab Classes TabConfiguring Printer Properties Printing from ApplicationsPrinting Files Installing printer driver for Macintosh Install the Printer driverUninstalling the Printer driver ML-3050 onlySetting Up the Printer For a Network-connected MacintoshFor a USB-connected Macintosh Select Socket/HP Jet Direct in Printer TypeChanging Printer Settings Layout SettingPrinting Printing a DocumentPrinter Features Setting ResolutionQualityPrinting Multiple Pages on One Sheet of Paper Reverse DuplexDuplex Printing Index Macintosh 31 uninstall Rev