Samsung ML-3050 manual Installing a wireless network interface card

6Push the DIMM straight into the DIMM slot until it snaps into place. Make sure the latches fit over the notches located on either side of the DIMM.

7Replace the control board cover.

8Reconnect the power cord and printer cable, and turn the printer on.

Setting the memory in the PostScript printer properties

After installing the memory DIMM, you need to select it in the printer properties of the PostScript printer driver so that you can use it.

1Make sure that the PostScript printer driver is installed in your computer. To installing the PostScript printer driver, you need to select Custom and put a check mark on the PostScript printer driver. See the Software Section.

2Click the Windows Start menu.

3For Windows 95/98/Me/NT4.0/2000, select Settings and then Printers.

For Windows XP/2003, select Printers and Faxes.

4Select the Samsung ML-3050 Series PS printer.

5Click the right mouse button on the printer icon and select Properties.

6For Windows 95/98/Me, select Device Option tab.

For Windows NT4.0/2000/XP/2003, select Device Settings tab.

7Select the amount of memory you installed from Printer Memory in the Installable Option section.

For Windows 98, select Installable Option → VMOption → change setting for:NMOption → change memory.

8Click OK.

Installing a wireless network interface card

The ML-3051N and ML-3051ND is equipped with a network interface which allows you to use your printer on a network. You can also purchase a wireless network interface card to enable the use of the printer in wireless network environments

To use the ML-3050 in network environments, you need to buy an optional wired or wireless network printer server. For information about installing the network printer server, see the network printer server user’s guide.

For order information, see page 7.1.

Review the precautions on page 10.1 and then follow this procedure to install the wireless network interface card in your printer.

1Turn the printer power off and unplug all cables from the printer.

2Grasp the control board cover and slide toward you to open it.

1

1 control board cover

10.2 <Installing accessories>