Samsung ML-4050ND manual Troubleshooting, Clearing paper jams

Page 44

9 Troubleshooting

This chapter provides helpful information for what to do if you encounter an error while using your printer.

This chapter includes:

Clearing paper jams

Troubleshooting checklist

Understanding the status LED

Understanding display messages

Toner cartridge-related messages

Solving general printing problems

Solving print quality problems

Common Windows problems

Common Macintosh problems

Common PostScript problems

Common Linux problems

Clearing paper jams

Note

• When removing paper that is jammed in the printer, if possible always pull the paper in the direction that it normally moves so as not to damage internal components. Always pull firmly and evenly; do not jerk the paper. If the paper tears, ensure that all

fragments of paper are removed; otherwise a jam will occur again.

When a paper jam occurs, the Status LED lights red. Open and close the top cover. The jammed paper automatically exits the printer.

If the paper does not exit, check the display on the control panel. The message indicating the corresponding location of the paper jam appears. Refer to the table below to locate the paper jam and to clear it:

Message

Location of Jam

Go To

 

 

 

Paper Jam 0

In the paper feed area

the next

Open/Close Door

(tray 1, optional tray 2,

column

 

optional tray 3, optional tray 4,

 

 

multi-purpose tray)

 

 

 

 

Paper Jam 1

Around the toner cartridge

page 9.3

Open/Close Door

 

 

 

 

 

Paper Jam 2

In the paper exit area

page 9.4

Check Inside

 

 

 

 

 

Paper Exit Jam 1

Between the toner cartridge

page 9.3

Open/Close Door

and the paper exit area

 

 

 

 

 

 

Paper Tray 2 Jam

In the optional tray 2

page 9.2

Open Tray 2

 

 

 

 

 

Paper Tray 3 Jam

In the optional tray 3

page 9.2

Open Tray 3

 

 

 

 

 

Paper Tray 4 Jam

In the optional tray 4

page 9.2

Open Tray 4

 

 

 

 

 

Duplex Jam 0a

In the duplex area

page 9.4

Check Inside

 

 

 

 

 

Duplex Jam 1a

In the duplex area

page 9.5

Open/Close Door

 

 

 

 

 

a. Available with the optional duplex unit.

9.1 <Troubleshooting>

Image 44
Contents Page Page Contact Samsung World Wide Country Customer Care Center Web SiteContents Specifications TroubleshootingInstalling accessories Safety and Regulatory Information Important Precautions and Safety InformationEnvironmental and Safety Consideration Laser Safety StatementOzone Safety Power SaverRecycling Radio Frequency EmissionsUnited States of America Declaration of Conformity European CountriesReplacing the Fitted Plug for UK Only Wireless GuidanceRegulatory Compliance Statements Software section Special featuresIntroduction Print in various environments Printer overview Front viewFinding more information Control panel overviewSelecting a location Clearance spaceAccessing control panel menus System setupUsing control panel menus Information menu Menu overviewJob manager menu Layout menu Paper menuSystem Setup menu Graphic menuEmulation menu PostScriptChanging the display language Using toner save modePrinting a demo Contents Software overviewSupplied software Postscript Printer Description PPD file UseWindows Printer driver featuresSystem requirements Linux MacintoshVia the control panel Network setupVia network administration programs Configuring TCP/IP Configuring EtherTalkDynamic addressing BOOTP/DHCP Supported operating systemsConfiguring IPX frame types Setting Ethernet speedRestoring the network configuration Printing a network configurationLoading print media Selecting print mediaType Size Dimensions Weighta Capacityb Type Size WeightSupported sizes of paper Print media for duplex printingMedia type Guidelines Guidelines for selecting and storing print mediaGuidelines for special print media Loading paper Using the standard tray or the optional trays Changing the size of the paper in the trayUsing the multi-purpose tray Load the paper with the side to be printed on facing upUsing manual feed mode Tips on using the multi-purpose trayPrinting to the rear cover Face up Selecting an output locationPrinting to the output tray Face down Canceling a print job Printing a document Canceling a print jobBasic printing Printing a documentToner cartridges Ordering supplies and accessoriesAccessories How to purchase Maintenance Cleaning the printerCleaning the outside of the printer Cleaning the inside of the printerPTL lens Maintaining the toner cartridge Checking the remaining tonerRedistributing toner cartridge Replacing the toner cartridge Items Yield Average Maintenance partsClearing the Toner Low Replace Toner message Troubleshooting Clearing paper jamsOptional tray Paper feed areaTray Around the toner cartridge Multi-purpose trayDuplex jam Paper exit areaDuplex unit area Tips for avoiding paper jams Troubleshooting checklistCondition Suggested solutions Understanding the status LED Understanding display messagesMessage Meaning Suggested solutions Load Low Heat ErrorLSU Motor Error OPC is CleaningToner cartridge-related messages Solving general printing problems Settings and Printers. Right Spool Settings buttonClick the Samsung ML-4050 Series PCL 6 printer iconSolving print quality problems Condition Suggested solutions Vertical RepetitiveDefects ScatterCommon Windows problems Common PostScript problemsCommon Linux problems Common Macintosh problemsInstallable Options section to InstalledInstalling accessories Precautions when installing accessoriesInstalling a memory Dimm Disconnect the power cordSelect the Samsung ML-4050 Series PS printer Setting the memory in the PostScript printer propertiesSelect the Device Settings tab Installing a wireless network interface card Removing a DimmSelecting the authentication type Configuring the wireless network parametersConfiguring basic network settings Using the hard disk Installing the hard diskSetting Encryption Restoring default values for wireless networkingSetting the hard disk in the printer properties Setting the time and datePrinting with the optional hard disk Storing a jobPrinting a stored job Deleting a stored jobControlling the active job queue To delete a file from the queueTo print a file immediately Printing using the form filesTo promote a file from the queue Specifications and Description SpecificationsPrinter specifications Index System requirements Linux 3.3 Macintosh 3.3 Windows Software section Contents Using Windows Postscript Driver Using Your Printer with a Macintosh Typical Installation Installing Printer SoftwareInstalling Software for Local Printing Custom Installation Select Typical installation for a local printer. Click NextSelect Custom installation. Click Next Installing Software for Network Printing Installing Printer Software in Windows Custom Installation Installing Printer Software in Windows Reinstalling Printer Software Select the components you want to reinstall and click NextRemoving Printer Software NextPrinting a Document Select your printer driver from the Name drop-down listPaper Orientation Printer SettingsLayout Tab Scaling Printing Paper TabSource Image Mode ResolutionToner Save Mode Graphics TabExtras Tab Job SettingOn the Job Setting Using a Favorite Setting Using HelpAbout Tab Printer TabAdvanced Printing Printing Multiple Pages on One Sheet of Paper N-Up PrintingPrinting Posters Printing BookletsPrinting on Both Sides of Paper Printing a Reduced or Enlarged DocumentFitting Your Document to a Selected Paper Size NoneUsing Watermarks Using an Existing WatermarkCreating a Watermark Editing a WatermarkUsing Overlays What is an Overlay?Using a Page Overlay Creating a New Page OverlayUsing Windows PostScript Driver AdvancedFrom the Direct Print Utility window Overview Direct Print UtilityPrinting Setting Up a Host Computer Setting Up a Client ComputerCheck the Share this printer box Select Local Port and click New PortTroubleshooting Guide Printer SettingUnderstanding Smart Panel Toner LevelOpening the Troubleshooting Guide Using Printer Settings UtilityChanging the Smart Panel Program Settings Using Onscreen Help FileGetting Started Installing the Unified Linux DriverInstalling the Unified Linux Driver Uninstalling the Unified Linux Driver Click UninstallUsing the Unified Driver Configurator Printers ConfigurationOpening the Unified Driver Configurator Double-clickUnified Driver Configurator on the desktopClasses Tab Configuring Printer PropertiesPorts Configuration Printing from Applications Printing FilesInstalling Software for Macintosh Install the Printer driverUninstalling the Printer driver Click ContinueSetting Up the Printer For a Network-connected MacintoshFor a USB-connected Mac OS 8.6 ~Printing a Document Changing Printer SettingsLayout Setting Printer Features Setting ResolutionQualityPrinting Multiple Pages on One Sheet of Paper Reverse DuplexDuplex Printing Index Image mode 15 resolution Macintosh GGGGGGGGGGGGGRev.9.00