Other connections | 09 |
SCART pin assignment
The diagram below shows the SCART
Line Out options
The Line Out function allows you to determine how sound from LINE OUT and AV
CONNECTOR terminals is output.1
Pin No. | Assignment | Pin No. | Assignment |
1 | Audio R OUT | 12 | No connection |
|
|
|
|
2 | Audio R IN | 13 | GND (video) |
|
|
|
|
3 | Audio L OUT | 14 | GND (video) |
|
|
|
|
4 | GND (audio) | 15 | R or C OUT |
|
|
|
|
5 | GND (video) | 16 | BLANK OUT |
|
|
|
|
6 | Audio L IN | 17 | GND (video) |
|
|
|
|
7 | B OUT | 18 | GND (video) |
|
|
|
|
8 | Status | 19 | Video or Y OUT |
|
|
|
|
9 | GND (video) | 20 | No connection |
|
|
|
|
10 | No connection | 21 | GND (video) |
|
|
|
|
11 | G OUT |
|
|
|
|
|
|
•Press LINE OUT to cycle through LINE ON and LINE OFF options, then press ENTER to confirm you selection.
•LINE ON – Multichannel sources are downmixed to 2.1 ch (stereo). For both LINE OUT and AV CONNECTOR terminals a 2 ch downmix signal is produced.
•LINE OFF – For regular multichannel playback through your speaker system. Note that no signal is produced from the LINE OUT terminal: AV CONNECTOR sound is output in Left/Right channels only.
Connecting using HDMI
If you have a HDMI or DVI (with HDCP) equipped monitor or display, you can connect it to this player using a commercially available
HDMI cable for high quality digital video.2
See About HDMI below for more about the HDMI connection.
Note
1• When the line out mode is on, most sound features cannot be used. The display will briefly blink LINE ON if you try and use a prohibited function while the line out mode is on.
•The line out mode switches off if you change the input function (DVD/CD, TUNER, etc.) or switch the power off.
•This option is not effective when listening a source from LINE2.
2• An HDMI connection can only be made with
•Depending on the component you have connected, using a DVI connection may result in unreliable signal transfers.
•When you change the component connected to the HDMI output, you will also need to change the HDMI settings to match the new component (see Video Output settings on page 27 to do this).
33
En