Mitsubishi Electronics DX-TL950E Rear View, Main switch, Video OUT connectors, AC power socket

■Rear View

1 2 3 4

ON

MAIN

VIDEO

1

2

3

4

CAMERA IN

5

6

7

8

9

OFF

AC IN~

Y/C

1

2

3

4

CAMERA OUT 5

6

7

8

9

OUTPUT A

MODEOUT 4

MODEOUT 5

CALLOUT

CALLOUT GND

240V-100

MIC

1 2 3 4 5 6 7 8 9

CLOCKADJ REC EMERGENCY MODEOUT 1

MODEOUT 2 MODEOUT 3

GND 12VDCOUT

350mAMAX

ALARM IN

RS--232C

ETHERNET

OUTPUT B

OUT

AUDIO

IN

RESET

GND

RESET

RECEIVE

SEND

5	6	7 8	9	10	11	12	13
1. MAIN switch				This unit must be earthed at all times. Never con-
This is the main power switch. When using this unit,			nect this unit to a power outlet which does not have
set this switch to ON. Otherwise, the power cannot			an earth terminal.
be turned on/off using the POWER button on the front
of the unit.				Please use the AC power cord accessory.

ENGLISH

2.VIDEO OUT connectors

OUTPUT A VIDEO connector

Output connector for video signal to monitor (BNC connector).

OUTPUT A S(Y/C) connector

This is output connector for video signals that sepa- rate brightness signals and color signals for higher picture quality. Simultaneous output along with OUT- PUT A VIDEO is also possible.

OUTPUT B connector

Output connector for video signal to monitor only for live image (BNC connector)( see page 37). To display the image, set “OUTPUT B ON/OFF” on the <MPX DISPLAY SETTINGS> screen to “ON”. The playback image cannot be put out to the OUTPUT B connector.

3. CAMERA IN connectors

Input connector for signal of camera (BNC connector).

4. CAMERA OUT connectors

Camera video output connectors for use of BNC con- nectors. If the MAIN switch is ON, the loop through output is possible for the camera image inputted into each CAMERA IN connector.

5. AC power socket

This socket connects to the power cord. Earth ter- minal is for safety. Use the 100 ~ 240V plug with earth for the power of this unit.

6. GND terminals

It is the common GND terminal.

7.AUDIO connectors

AUDIO IN connector

Input connector for audio signal (RCA pin).

AUDIO OUT connector

Output connector for audio signal (RCA pin).

8. MIC jack

Input connector for microphone (600 ohm imped- ance). Use of MIC for audio recording has priority to use of the AUDIO IN connector.

9. RESET button

Pressing this button resets the unit and the power turns off. In this case, video data, menu settings and the current time are kept.

10.ALARM IN terminals

Input terminal for alarm signal.

11.I/O terminals

CLOCK ADJ terminal

Input terminal to set the present time. Time display is adjusted to the nearest hour (00 minutes 00 seconds) when this terminal receives the CLOCK ADJ signal.

INFORMATION

The on-screen clock can be reset to the nearest hour, by applying a signal to the CLOCK ADJ terminal. For example, if the current time is 11:29:59, it will be reset to 11:00:00, and if the current time is 11:30:00, it will be reset to 12:00:00.

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Beginning

13