Mitsubishi Electronics DX-TL950E operation manual RS-232C connector, Ethernet connector

Major operations and their functions (continued)

■Rear View (continued)

1 2 3 4

ON

MAIN

OFF

AC IN~

100-240V

VIDEO		1		2	3	4		CAMERA IN	5					6		7	8	9
Y/C		1		2	3	4	CAMERA OUT 5							6		7	8	9
OUTPUT A
						ALARM IN		CLOCKADJ REC EMERGENCY MODEOUT 1	MODEOUT 2 MODEOUT 3	MODEOUT 4	MODEOUT 5	CALLOUT	CALLOUT GND	GND DC12V OUT	MAX350mA
					1 2 3 4 5 6 7 8 9											RS--232C	ETHERNET
					MIC
OUTPUT B	OUT	AUDIO	IN		RESET
GND					RESET												RECEIVE	SEND

5 6 7 8 9 10 11 12 13

REC terminal

Input terminal to start recording. Not available dur- ing timer recording.

EMERGENCY terminal

Input terminal initiating immediate shift to EMER-

GENCY recording mode compulsorily.

MODE OUT 1 ~ MODE OUT 5 terminals

Output terminal to indicate the unit’s current mode. Select the unit’s condition by MODE OUT 1 ~ MODE OUT 5 setting in the <REAR TERMINAL SETTINGS> menu.

CALL OUT terminal / CALL OUT GND terminals This is the ISOLATION output terminal. Information that can be transmitted externally consists of CALL OUT settings made on the <REAR TERMINAL SET- TINGS> menu screen as well as fixed output set- tings.

DC 12V OUT terminal

Will only output when the MAIN switch is ON. The maximum electric current is 350mA.

12. RS-232C connector

This connector is used to connect to host device with RS-232C connector. This unit can be controlled by another device through this connector.

13. ETHERNET connector

Use a 10BASE-T cable to connect to the Ethernet terminal. Please use the cable adapted to 10BASE- T. DUPLEX MODE is HALF DUPLEX.

RECEIVE indicator

Illuminates when the unit is receiving a signal.

SEND indicator

Illuminates when the unit is transmitting a signal.

••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••Beginning

14