Mitsubishi Electronics WD-62528 Remote Control Operational Modes, Two Electrical Adjustments

MODEL: WD-52527 / WD-52528 / WD-62527 / WD-62528

Remote Control Operational Modes

There are two Remote Hand Unit Operational Modes, “Standard” and “NetCommandTM”. The Remote is initially in the “Standard” mode. The “NetCommand” mode is used when controlling Home Theater devices using NetCommand. To change the Remote Operational Mode:

•Set the Remote to the TV Layer

•Point the Remote away from the TV.

•To change to “Netcommand” ... Hold the “Power” button and press “9-3-5” in sequence.

•To change to “Standard” ... Hold the “Power” button and press “0-0-0” in sequence.

SERVICE ADJUSTMENTS

There are only 4 Service Adjustments required in these models:

Two Electrical Adjustments

• Horizontal Centering

• Vertical Centering

Two Mechanical Adjustment

• Picture Rotation

• Vertical Keystone Distortion

Measuring equipment and Jigs

• Conventional Electrical and Hand Tools.

• No additional Test Equipment is required.

Test signal

An internally generated Test Signal is used, no additional signals are required.

Circuit Adjustment Mode

On these models, the Circuit Adjustment Mode is used only for:

•Internal Test Signal activation

•Horizontal Centering

•Vertical Centering

• Data Transfer

These functions can only be performed using the remote control.

1. Activating the Adjustment Mode

1.Press the “MENU” button on a remote hand unit. (The “MENU” display will appear.)

2. Press the buttons “2”, “4”, “5” and “7” in that order.

The screen will change to the Circuit Adjustment Mode. If change does not occur, repeat steps 1 and 2.

2. Test Signal Activation

When in the Circuit Adjustment mode, use the “REWIND” and “FAST FORWARD” buttons on the remote control to toggle through the test patterns. These patterns are used for both electrical and mechanical adjustments.

3. Adjustment Function Selection

Use the “AUDIO” button to select an Adjustment Function.

AD9881 Sub

Functions

fmt

Page 28