Mitsubishi Electronics CP700E External Remote 1 terminal on the rear panel, Timing Chart

8. Printing Procedures (Special prints)

TIMING CHART

Input signal level : TTL

Input timing : 1 word 38.4 ms

Input timing : Code : “0”

Input timing : Code : “1”

Example: print code = 13=010011

11

1.6 ms

0.4 ms

3.2 ms

0.4 ms

0 0 1

0

External REMOTE 1 terminal on the rear panel

• The pin number on the positive pin is shown below.

3

2 1 1 3 2

1External remote terminal Signal allocation Connector REMOTE 1

Pin No.	Function	Description
1	Ground	Earth
2	MEMORY	Memory: When the signal becomes “LOW” from “HIGH”, the image is stored
		in memory. (When the signal has been “LOW” for 60msec. or more, the image
		is stored in memory.)
3	BUSY	When “REMOTE BUSY” is set to “HIGH”
		“HIGH” : The VCP cannot accept the remote signal.
		“LOW” : The VCP can accept the remote signal.
		The signal becomes “HIGH” in the following cases;
		(1)	During initialization after the VCP has been switched on
		(2)	For about 1 sec. after the INPUT SELECT switch has been set
		(3)	During displaying the menu screen
		(4)	When the image cannot be stored in memory

83