JVC XV-SA75GD manual Only for Dolby Digital DVD Video Discs

Page 60

6$￿￿￿(1*￿ERRN￿￿3DJH￿￿￿￿￿0RQGD\￿￿-XQH￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿30

Initial settings

COMPRESSION

(only for Dolby Digital DVD VIDEO Discs)

When enjoying a DVD VIDEO

 

 

 

 

disc recorded with the Dolby

PREFERENCE1

PREFERENCE2

SPK. SETTING

Digital format at low or

DOWN MIX

 

 

Lo/Ro

middle volume, setting

DIGITAL AUDIO OUTPUT

STREAM/PCM

DTS BASS MANAGEMENT

 

OFF

COMPRESSION to ON makes

COMPRESSION

 

ON

SCREEN SAVER

 

MODE1

 

 

AUTO STANDBY

 

OFF

you hear sound comfortably.

AV COMPULINK MODE

 

DVD1

SELECT

KEY

 

 

•

ON

 

 

 

 

 

Audio is played back with the dynamic range

 

 

compressed.

 

 

 

 

•

OFF

 

 

 

 

 

Audio is played back as it was recorded.

 

 

•60

Time is set to 60 minutes.

•30

Time is set to 30 minutes.

•OFF

The auto standby function is off.

SCREEN SAVER

A television monitor screen may be burned out if a static picture is displayed for a long time. To prevent this, the unit automatically activates the screen saver function if a static picture, such as an on-screen display or menu, is displayed for over 5 minutes.

NOTES

•The “COMPRESSION” function works only when playing back a disc recorded with DOLBY DIGITAL. The setting is not effective for other discs.

•The “COMPRESSION” function does not work when the 3D PHONIC function is activated.

DTS BASS MANAGEMENT

This item controls the

•MODE 1

The current picture gets dark.

•MODE 2

The “screen saver” picture appears and its brightness changes.

•OFF

PREFERENCE1

PREFERENCE2 SPK. SETTING

DIGITAL AUDIO OUTPUT

STREAM/PCM

DOWN MIX

 

Lo/Ro

COMPRESSION

ON

DTS BASS MANAGEMENT

OFF

AUTO STANDBY

OFF

SCREEN SAVER

MODE1

AV COMPULINK MODE

DVD1

SELECT

KEY

 

Initial settings

output signals when playing

PREFERENCE1

PREFERENCE2 SPK. SETTING

back DTS-encoded DVD

DIGITAL AUDIO OUTPUT

STREAM/PCM

VIDEO discs.

DOWN MIX

 

Lo/Ro

COMPRESSION

ON

 

DTS BASS MANAGEMENT

OFF

 

AUTO STANDBY

OFF

 

SCREEN SAVER

MODE1

 

AV COMPULINK MODE

DVD1

 

SELECT

KEY

 

•OFF

This is the normal setting for DTS-encoded discs. Signals with the full frequency range are output from all speakers when playing back a DTS-encoded disc. This mode ignores all “Small” settings in the speaker setting screen (All “Small” settings are regarded as “Large”).

•ON

All speaker settings (front, center and rear) in the speaker setting screen are effective when playing back DTS-encoded discs. The low frequency signal fed from the sub-woofer output is boosted up regardless of the “Bass redirect setting” in the speaker setting screen.

See page 59 for the speaker setting screen.

The screen saver function is off.

NOTES

•The monitor screen of a projector or projection TV is easily burned out if a static picture is displayed for a long time. Be careful not to allow the monitor screen to be burned out when you set the SCREEN SAVER mode to “OFF”.

•The TV screen may be garbled when you set the SCREEN SAVER mode to “MODE 1”. In this case, set to another mode.

AV COMPULINK MODE

 

 

 

If you use the AV COMPU

 

 

 

LINK system, you must set

PREFERENCE1 PREFERENCE2

SPK. SETTING

this item correctly.

DIGITAL AUDIO OUTPUT

STREAM/PCM

Select from the three options:

DOWN MIX

 

Lo/Ro

COMPRESSION

 

ON

“DVD1”, “DVD2” and “DVD3”

DTS BASS MANAGEMENT

 

OFF

AUTO STANDBY

 

OFF

according to the equipment to

SCREEN SAVER

 

MODE1

AV COMPULINK MODE

 

DVD1

be connected.

SELECT KEY

 

 

 

 

 

See page 64.

 

 

 

AUTO STANDBY

When the unit is stopped for more than 30 minutes or 60 minutes, the unit enters standby mode automatically.

PREFERENCE1

PREFERENCE2

SPK. SETTING

DIGITAL AUDIO OUTPUT

STREAM/PCM

DOWN MIX

 

 

Lo/Ro

COMPRESSION

 

ON

DTS BASS MANAGEMENT

 

OFF

AUTO STANDBY

 

OFF

SCREEN SAVER

 

MODE1

AV COMPULINK MODE

 

DVD1

SELECT

KEY

 

 

58

Page 59 Page 61
Image 60
Page 59 Page 61
Contents 96$%.96$ LET0185-001BMises en garde, précautions et indications diverses Table of Contents Features IntroductionDolby Digital Supplied accessories AV compluink cable xTo select a scene angle from the angle list display Angle Press and hold Angle for more than 1 second÷ During DVD Video playback Safety precautions Important cautionsPreliminary knowledge Names of parts and controlsFront panel OPEN/CLOSE buttonMulti-information window PROGRAM/RANDOM indicators Display windowRear panel Remote control unit @ Infrared signal-emitting window TV/VIDEO Cancel button 23Button Previous button 27, 32Operational Principles On-screen displaysBasic operations of on-screen displays Opening displayParental Lock display see DVD Control for DVD Video displayDVD Control for DVD Audio display To bring up the Parental Lock displayTo prevent the monitor from burning out Screen Saver CD Control displayVCD Control display MP3 Control display seeHow to use numeric buttons On-screen guide iconsAbout discs Playable disc typesAudio formats Playable discsDisc structure Example DVD Audio disc Group Track Example Audio CD/Video CDGetting started ConnectionsBefore making any connections To connect to a conventional TVHow to make the Progressive scan mode active To connect to a TV with the component video input jacksBlue Component video cable Green Red Unit Supplied Red White Audio cable Supplied Blue GreenAbout Scan Mode To connect to an audio amplifier or receiverRed White Audio cable Supplied Amplifier or receiver Audio/Video Cable Supplied To connect to audio equipment with a digital input Using the remote control unit To connect the power cordTo install batteries in the remote control unit Precautions for the safe use of batteries PrecautionRemote sensor Remote sensorTo use the remote control unit for TV operation Setting the remote control signal for operating your TVYou can operate your TV from the remote control unit Manufacturer code list+10 Basic operations Turning on/off the unitInserting and removing discs Press 0 OPEN/CLOSE to close the disc trayBasic playback To start playbackTo stop playback completely To stop playback temporarilyMethod 1 from the remote control unit only To advance or reverse playback rapidly while monitoringTo locate the beginning of the scene or song MethodResuming playback To memorize the interrupted positionTo resume playback Unit memorizes the interrupted positionAdvanced operations DVDVideo Audio To locate a desired scene from the DVD menu Press TOP Menu or MenuUse the numeric buttons to select the desired item ¶ Whenever a DVD disc is loadedUnit status Disc type What is Specified Use the numeric buttons to specify the numberUnit starts playback from the beginning SelectionTo locate a desired selection using 4 or ¢ Press on ScreenPress Enter Message area For DVD AudioUse Cursor 5/∞ to move to Time SEARCH, then press Enter Use the numeric buttons 0 to 9 to enter the timeScreen example Selected time Message area For Audio CDWhen you make a mistake To locate a desired scene from the display DigestPress Digest Use Cursor 5/∞/2/3 to move to select the desired sceneSpecial picture playback To playback in slow-motion SlowTo display continuous still pictures Strobe Press and hold 8 for more than 1 secondUse Cursor 5/∞/2/3 to move the zoomed position Press Zoom + orTo return to normal playback Press Enter ¶ During playback or while pausedChanging the playback order To playback in the desired order ProgramTo playback in random order Random Use Cursor 5/∞ to move to RandomTo quit program playback To quit random playback in the middleRepeat playback To repeat the current selection or all tracks RepeatPress Repeat Use Cursor 5/∞ to move to REPEAT, then press EnterTo repeat a desired part A-B Repeat Audio CD/Video CDDisc type Display window On-screen display To stop repeat playbackSelecting a scene angle To select a scene angle from the normal screen AngleFrom normal screen Press AngleFrom on-screen display Use Cursor 2/3 or Angle to select the desired angle numberTotal number Recorded anglesChanging the language and sound To select the subtitle language SubtitleFrom on-screen display DVD Video only English To change the audio language or sound Audio Use Cursor 5/∞ or Audio S.FREQ to move to AudioPress Audio S.FREQ Use Audio S.FREQ or Cursor 2/3 to select the desired audioSelected preset Miscellaneous functionsLevel ParameterAdjust the level of the parameter using Cursor 2/3 Select the desired mode by using 3D PhonicTo simulate surround sound 3D Phonic Press 3D PhonicPress Cursor 2/3 to adjust the effect level Use Cursor 5/∞ to move to Time SelectTotal Total RemainTo select a still picture on a DVD Audio disc From normal displayUse Cursor 5/∞ or page to move to Use Cursor 2/3 or page to select the desiredTo playback a bonus group of a DVD Audio disc Press Cursor 5 or ∞ while holding downDisplay Window TV screen Checking the sampling frequency Press Audio S.FREQ for more than one secondActual sampling frequency Display window What is MP3? MP3 disc playbackAbout MP3 disc OperationsHighlight a desired Group using Cursor Press Enter or Highlight a desired Track using CursorSpecifying the desired Group and Track Track timeRepeat playback You can repeat playback of the current track or group¶ During playback or while stopped Initial settings How to set preferencesSelecting preferences Language and display preferenceEnglish FrenchSpanish Audio and system preference STREAM/PCM Dolby DIGITAL/PCMStream Dolby Digital PCM only Only for Dolby Digital DVD Video Discs Speaker setting Speaker Channel settingBass redirect Available only when selecting Expert Speaker size settings Available only when selecting ExpertTest tone Available only while setting Level or Delay Available only when selecting ExpertLimiting playback by children To set Parental Lock for the first timeWhile Points Set Level, use Cursor To select the parental lock levelTo change the settings Press Enter while holding down 7 on Remote control unitTo select the desired country code Select the desired level whileEnter your 4-digit password using the numeric buttons 0 to When selecting noUse the Cursor 5/∞ to move to YES, then press Enter Press 0 OPEN/CLOSEAV Compu Link remote control system Connection and setupAdditional information Turn on the main power of the television OperationYou connect the component video output to your TV How to handle discs Maintenance of discsCare and handling of discs Label sideTroubleshooting Symptom Possible case RemedySpecifications Appendix a Table of languages and their abbreviations Appendix B Country code list for parental lock Authorized Service Centers Limited Warranty JVC 0601AOMDTEJSC
Top Page Image Contents