JVC XV-SA75GD manual Test tone Available only while setting Level or

Page 62

6$￿￿￿(1*￿ERRN￿￿3DJH￿￿￿￿￿0RQGD\￿￿-XQH￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿30

Initial settings

2 Select the desired speaker(s) to be set using CURSOR 5/∞.

•F.SP: Front speakers. the level is fixed to 0dB.

•C.SP: Center speaker

•R.SP: Rear speakers

•S.WOOFER: Sub-woofer

The setting range is between –6dB and +6dB in 1dB steps.

Test tone

(available only while setting LEVEL or

DELAY)

You can check the level

 

 

 

 

 

setting by monitoring the

PREFERENCE1

PREFERENCE2

SPK.SETTING

test tone.

 

 

 

EXPERT

 

 

 

LEVEL

 

 

 

 

DELAY

 

 

BASS

 

F. SP

0dB

 

 

 

C. SP

0dB

 

 

 

 

R. SP

0dB

 

 

 

 

S.WOOFER

0dB

 

PRESS

KEY

TEST TONE

Initial settings

3 Set the level using CURSOR 2/3.

•For the speaker(s) whose size is set to “None”, the Speaker level and Delay cannot be set (“—”appears in the setting field).

•However, when playing back a Dolby Digital disc, LFE singal is output from SUBWOOFER output even if

S. WOOFER shows “—”, allowing to activate a sub-woofer connected. In such case, adjust the output level using the level control on the sub-woofer.

Delay

(available only when selecting EXPERT)

You can adjust the delay

 

 

 

 

 

time of each speakers.

PREFERENCE1

PREFERENCE2

SPK.SETTING

 

 

 

 

EXPERT

 

 

 

 

LEVEL

 

 

 

 

DELAY

 

 

BASS

 

F. SP

0mS

 

 

 

C. SP

0mS

 

 

 

 

R. SP

0mS

 

 

 

 

S.WOOFER

0mS

 

PRESS

KEY

TEST TONE

1 Select [DELAY] using CURSOR 5/∞, then press ENTER.

The color of “DELAY” changes.

2 Select the desired speaker(s) to be set using CURSOR 5/∞.

•F.SP: Front speakers. the delay is fixed to 0mS.

•C.SP: Center speaker (selectable from 0 to –5mS in 1mS units)

•R.SP: Rear speakers (selectable from 0mS,

–5mS, –10mS, and –15mS)

3 Set the delay time using CURSOR 2/3.

1 Select [TEST TONE] using CURSOR 5/∞, then press ENTER.

The color of “TEST TONE” changes.

2 Select the desired speaker(s) using CURSOR

5/∞.

•F.SP: Front speakers

•C.SP: Center speaker

•R.SP: Rear speakers

After selecting the Test tone, if you do not move the cursor, the test tone is output from each speaker one by one.

In Test tone mode, if you move down from

“R.SP” position, the test tone continues to output from the rear speakers as long as is any position other than “F.SP” and “C.SP”. Similarily, if you move up from “F.SP” position, the test tone continues to output from the front speakers as long as is any position other than “C.SP” and “R.SP”.

3 Set the level using CURSOR 2/3 again, if necessary.

•In Test tone mode, you hear pink noise, which includes all frequencies in the audible range, from the speakers. This is not a malfunction.

•The test tone is not output from the SUBWOOFER output.

NOTE

•To exit the test tone mode

Move to [TEST TONE] in the on-screen display and press ENTER until [TEST TONE] returns to its original color.

•Delay of S.WOOFER cannot be set.

NOTE

•To exit the speaker level (or delay) setting mode

Move to [LEVEL] (or [DELAY]) in the on-screen display and press ENTER until [LEVEL] (or [DELAY]) returns to its original color.

60

Page 61 Page 63
Image 62
Page 61 Page 63
Contents 96$%.96$ LET0185-001BMises en garde, précautions et indications diverses Table of Contents Dolby Digital FeaturesIntroduction Supplied accessories AV compluink cable x÷ During DVD Video playback To select a scene angle from the angle list display AnglePress and hold Angle for more than 1 second Safety precautions Important cautionsFront panel Preliminary knowledgeNames of parts and controls OPEN/CLOSE buttonRear panel Multi-information window PROGRAM/RANDOM indicatorsDisplay window Remote control unit Button @ Infrared signal-emitting windowTV/VIDEO Cancel button 23 Previous button 27, 32Basic operations of on-screen displays Operational PrinciplesOn-screen displays Opening displayDVD Control for DVD Audio display Parental Lock display seeDVD Control for DVD Video display To bring up the Parental Lock displayVCD Control display To prevent the monitor from burning out Screen SaverCD Control display MP3 Control display seeHow to use numeric buttons On-screen guide iconsAudio formats About discsPlayable disc types Playable discsDisc structure Example DVD Audio disc Group Track Example Audio CD/Video CDBefore making any connections Getting startedConnections To connect to a conventional TVBlue Component video cable Green Red Unit Supplied How to make the Progressive scan mode activeTo connect to a TV with the component video input jacks Red White Audio cable Supplied Blue GreenRed White Audio cable Supplied Amplifier or receiver About Scan ModeTo connect to an audio amplifier or receiver Audio/Video Cable Supplied To connect to audio equipment with a digital input To install batteries in the remote control unit Using the remote control unitTo connect the power cord Remote sensor Precautions for the safe use of batteriesPrecaution Remote sensorYou can operate your TV from the remote control unit To use the remote control unit for TV operationSetting the remote control signal for operating your TV Manufacturer code list+10 Inserting and removing discs Basic operationsTurning on/off the unit Press 0 OPEN/CLOSE to close the disc trayTo stop playback completely Basic playbackTo start playback To stop playback temporarilyTo locate the beginning of the scene or song Method 1 from the remote control unit onlyTo advance or reverse playback rapidly while monitoring MethodTo resume playback Resuming playbackTo memorize the interrupted position Unit memorizes the interrupted positionVideo Audio Advanced operationsDVD Use the numeric buttons to select the desired item To locate a desired scene from the DVD menuPress TOP Menu or Menu ¶ Whenever a DVD disc is loadedUnit starts playback from the beginning Unit status Disc type What is SpecifiedUse the numeric buttons to specify the number SelectionPress Enter To locate a desired selection using 4 or ¢Press on Screen Message area For DVD AudioScreen example Use Cursor 5/∞ to move to Time SEARCH, then press EnterUse the numeric buttons 0 to 9 to enter the time Selected time Message area For Audio CDPress Digest When you make a mistakeTo locate a desired scene from the display Digest Use Cursor 5/∞/2/3 to move to select the desired sceneTo display continuous still pictures Strobe Special picture playbackTo playback in slow-motion Slow Press and hold 8 for more than 1 secondTo return to normal playback Press Enter Use Cursor 5/∞/2/3 to move the zoomed positionPress Zoom + or ¶ During playback or while pausedChanging the playback order To playback in the desired order ProgramTo quit program playback To playback in random order RandomUse Cursor 5/∞ to move to Random To quit random playback in the middlePress Repeat Repeat playbackTo repeat the current selection or all tracks Repeat Use Cursor 5/∞ to move to REPEAT, then press EnterDisc type Display window On-screen display To repeat a desired part A-B RepeatAudio CD/Video CD To stop repeat playbackFrom normal screen Selecting a scene angleTo select a scene angle from the normal screen Angle Press AngleTotal number From on-screen displayUse Cursor 2/3 or Angle to select the desired angle number Recorded anglesFrom on-screen display DVD Video only English Changing the language and soundTo select the subtitle language Subtitle Press Audio S.FREQ To change the audio language or sound AudioUse Cursor 5/∞ or Audio S.FREQ to move to Audio Use Audio S.FREQ or Cursor 2/3 to select the desired audioLevel Selected presetMiscellaneous functions ParameterTo simulate surround sound 3D Phonic Adjust the level of the parameter using Cursor 2/3Select the desired mode by using 3D Phonic Press 3D PhonicTotal Press Cursor 2/3 to adjust the effect levelUse Cursor 5/∞ to move to Time Select Total RemainUse Cursor 5/∞ or page to move to To select a still picture on a DVD Audio discFrom normal display Use Cursor 2/3 or page to select the desiredDisplay Window TV screen To playback a bonus group of a DVD Audio discPress Cursor 5 or ∞ while holding down Actual sampling frequency Display window Checking the sampling frequencyPress Audio S.FREQ for more than one second About MP3 disc What is MP3?MP3 disc playback OperationsSpecifying the desired Group and Track Highlight a desired Group using Cursor Press Enter orHighlight a desired Track using Cursor Track time¶ During playback or while stopped Repeat playbackYou can repeat playback of the current track or group Selecting preferences Initial settingsHow to set preferences Language and display preferenceSpanish EnglishFrench Audio and system preference Stream Dolby Digital PCM only STREAM/PCMDolby DIGITAL/PCM Only for Dolby Digital DVD Video Discs Bass redirect Available only when selecting Expert Speaker settingSpeaker Channel setting Speaker size settings Available only when selecting ExpertTest tone Available only while setting Level or Delay Available only when selecting ExpertWhile Points Set Level, use Cursor Limiting playback by childrenTo set Parental Lock for the first time To select the parental lock levelTo select the desired country code To change the settingsPress Enter while holding down 7 on Remote control unit Select the desired level whileUse the Cursor 5/∞ to move to YES, then press Enter Enter your 4-digit password using the numeric buttons 0 toWhen selecting no Press 0 OPEN/CLOSEAdditional information AV Compu Link remote control systemConnection and setup You connect the component video output to your TV Turn on the main power of the televisionOperation Care and handling of discs How to handle discsMaintenance of discs Label sideTroubleshooting Symptom Possible case RemedySpecifications Appendix a Table of languages and their abbreviations Appendix B Country code list for parental lock Authorized Service Centers Limited Warranty JVC 0601AOMDTEJSC
Top Page Image Contents