16 EN INSTALLING YOUR NEW UNIT
Basic Connections
TV aerial cable
Mains outlet
Mains power cord
To [ANTENNA IN]
Back of unit
|
| To |
| |
To |
| To | ||
To | OUT] | To | ||
[ANTENNA | ||||
[AUDIO |
| |||
| [COMPONENT | OUT] | ||
OUT] |
| |||
| VIDEO OUT |
| ||
Audio cable |
| |||
(Y/PB/PR)] |
| |||
(not supplied) | Component | |||
|
| |||
cable | video cable | |||
(supplied) | (not supplied) | |||
(not supplied) | ||||
|
|
RF cable (supplied)
TV
To 75 ohm terminal
It’s essential that your unit be properly connected.
ATTENTION:
Connect the AC plug only after all connections to the TV has been completed.
THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.
1Make sure the package contains all of the accessories listed in ASPECIFICATIONSB (A pg. 89).
2Place the unit on a stable, horizontal surface.
3Connect the unit to a TV depending on the TV and cables you use.
8Basic Connection
To connect to a TV with
ADisconnect the TV aerial cable from the TV.
BConnect the TV aerial cable to the [ANTENNA IN] connector on the rear panel of the unit.
CConnect the [ANTENNA OUT] connector on the rear panel of the unit and the TV’s aerial connector with the supplied RF cable.
DConnect the
●The
●Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV’s SCART connector.
NOTE:
The [ANTENNA OUT] connector is only used to pass antenna signal to the TV. It is necessary to connect the
8
To connect to TV’s
APerform A – C of ATo connect to a TV with
BConnect the unit’s
CConnect the unit’s [AUDIO OUT] connectors to the TV’s AUDIO input connectors.
●If your TV is not
●Set
8Component Video Connection
To connect to TV’s component video input connectors ^
APerform A – C of ATo connect to a TV with
BConnect the unit’s [COMPONENT VIDEO OUT (Y/PB/PR)] connectors to the TV’s component video input connectors.
CConnect the unit’s [AUDIO OUT] connectors to the TV’s AUDIO input connectors.
●You can obtain
●The [COMPONENT VIDEO OUT (Y/PB/PR)] connectors do not output DV signals.
●If your TV is not
●By using the component video connection, you can view the images in the progressive mode. For switching to the progressive mode, refer to AScan Mode Set (HDD & DVD Deck Only)B (A pg. 80).
NOTE:
Select an appropriate option of
When your TV’s SCART | Set | |
connector accepts: | ||
| ||
|
| |
Composite signals | ASCART VIDEOB | |
|
| |
Y/C signal (separated |
| |
luminance (brightness) and | ASCART | |
chrominance (colour) signals) |
| |
|
| |
RGB signal | ASCART RGBB | |
|
| |
Component video signal | ACOMPONENTB | |
|
|
When the setting selected is not in accordance with the TV connected and depending on the type of appliance connected to the unit, the correct picture will not appear.
4Plug the end of the mains power cord into a mains outlet.
●ALOADINGB blinks on the front display panel when the AC plug of the mains power cord is connected into a mains outlet and it takes approximately 50 seconds for the unit to be turned on. This is not a malfunction.