TROUBLESHOOTING EN 83
Timer Recording (HDD & DVD Deck)
Timer programming cannot be made.
●Date and time is not correct.
] Set date and time correctly. (A pg. 77)
●Timer recording is in progress.
] Timer programming can’t be performed while a timer recording is in progress. Wait until it finishes.
Timer programming recording does not start.
●Date and time is not correct.
] Set date and time correctly. (A pg. 77)
SHOWVIEW Timer Programming cannot be made.
●Date and time set on the unit is not correct. ] Set date and time correctly. (A pg. 77)
●The channel position does not correspond to that in the
receiving area.
] Set the correct channel position for the receiving broadcast. (A pg. 74)
The SHOWVIEW system does not timer record properly.
●The unit’s channel positions have been set incorrectly.
] Refer to ASHOWVIEW System SetupB (A pg. 74) and reperform the procedure.
Automatic Satellite Programme Recording does not start.
●The satellite receiver is not connected properly to this unit. ] Connect the satellite receiver to the
connector properly. (A pg. 48)
On the front display panel, A–
●Power failure occurred.
] Set date and time correctly. (A pg. 77)
APROGRAMME FULLB appears on the TV screen during timer programming.
●16 programmes have already been timer programmed.
] Clear unnecessary programmes on the unit, then try timer programming again. (A pg. 47)
The disc space does not increase when recorded titles are cleared.
Other Problems
The image of the TV broadcast appears distorted on the TV screen.
For basic connection
] Press PROGRESSIVE SCAN for 3 or more seconds so that the Video output indicator (q) lights off on the front display panel.
For component video connection
] Press PROGRESSIVE SCAN for 3 or more seconds so that the Video output indicator (q) lights up on the front display panel.
Whistling or howling is heard from the TV during camcorder recording.
●The camcorder’s microphone is too close to the TV.
] Position the camcorder so its microphone is away from the TV.
●The TV’s volume is too high. ] Turn the TV’s volume down.
When scanning channels, some of them are skipped over.
●Those channels have been designated to be skipped.
] If you need the skipped channels, restore them. (A pg. 75)
The channel cannot be changed.
●Recording or RetroActive Recording* is in progress.
] Press W to pause recording, change the channel, then press I to resume recording.
* HDD deck only
Channel settings that were made manually seem to have changed or disappeared.
●After the manual settings were made, Auto Channel Set was performed.
] Perform AClock SetB (A pg. 77).
Malfunction occurs and the unit cannot be power off.
] Reset the unit by disconnecting the AC power plug from the AC outlet and connect again.
●The PC’s data recorded on a
] Format the disc. (When the disc is soiled, wipe the disc with a soft dry cloth before formatting.) (A pg. 9, 78)