JVC LPT1100-001A manual Audio OUT

										EDITING EN 65
	Audio Dubbing (DV Deck Only)
										● Slide the TV/CABLE/SAT/DVD switch to DVD.
										1 Connect an audio device to the unit’s [AUDIO] input connectors
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with ADV AUDIO										on the front panel.
										● When using a monaural audio device, connect its AUDIO OUT
RECB set to A12BITB (A pg. 72).
										connector to the [AUDIO-L] input connector on your unit.
ATTENTION:										2 Load a Mini DV cassette with the erase protection switch set to
You cannot perform Audio Dubbing on a tape that was recorded										ARECB.
										3 Press DV/HDD/DVD SELECT on the unit repeatedly or DV on
with ADV AUDIO RECB set to A16BITB (A pg. 72), on a tape that
was recorded at the ALPB speed, or on a blank tape.										the remote so that the DV lamp lights up on the unit.
										4 Press PR +/– to select AF-1B.
		Your unit							Recorder	5 Start playback slightly before the actual point from where you
										wish to start dubbing.
										6 Press W to pause playback.
										7 Press A.DUB to engage the audio dubbing mode.
										● Your unit enters the Audio Dubbing Pause mode.
										● To perform Audio Dubbing with audio mixing, press AUDIO to
		To [AUDIO]			PR		+/-	A.DUB		select AL W X RB at this point. When using the DV deck as the
										recording deck, also make sure that AAUDIO MODEB is set to
			input
										ASOUND1B (A pg. 72).
										* Audio Dubbing with audio mixing is not possible if you are using a
				Audio cable						monaural audio component, or if you don’t have an audio mixer.
				(not supplied)						8 Engage the audio device’s playback, then press I to start the
										tape in the unit. Audio dubbing starts at this point.
				AUDIO OUT						● To stop dubbing temporarily, press W. Press I to resume
										dubbing.
										9 Press o on the unit, then stop playback on the audio device to
				CD player, etc.
										end the audio dubbing.
										NOTES:
										● Once the Audio Dubbing starts, you cannot use the other deck.
										● When monitoring the audio dubbed sound on the DV deck, set
										AAUDIO MODEB to ASOUND2B (A pg. 72).
										● Audio Dubbing is also possible with the [L-1 IN/OUT] or [L-2 IN/
				CD player, etc.
										DECODER] connector on the rear panel. When using these 21-
										pin SCART connectors, be sure to select the correct input mode
										(AL-1B or AL-2B) in step 4.
						Mixer output			Audio mixer	● When playing back an audio dubbed Mini DV tape on the DV
										deck, set AAUDIO MODEB to ASOUND2B (A pg. 72).
										● Audio dubbing is not possible using the [DV IN/OUT] connector.
										● Audio dubbing is not possible on a blank portion of the tape.

	Original sound
Your unit	[AUDIO OUT]

Recorder

PR +/-	A.DUB
To
[AUDIO]
input