JVC VR601 instruction manual

Page 29

5.Attach the interface connector and the power connector to the drive. Please note the red lining of the IDE cable and the red wire of power cable must line up side by side.

6.Place the hard-disk drive inside mobile rack, Use four of the provided screws.

7.Place the top cover back to the carrier body by sliding forward to secure.

8. Slide the carrier body back in the mobile rack.

9. Push the carrier body further into the mobile rack until fully inserted.

10. Push the active-handle inward.

11. Lock the Key.

Image 29

Contents Digital Video Recorder Avertissement Safety Precautions for USA and CanadaPower System Safety Precautions for Europe and AustraliaTable Of Contents Product Introduction Product FeaturesProduct Features Front View Description of the FRONT/REAR ViewNo Connection Rear View Alarm In/OutʽTHIS Figure is Looked from the Rear Connecting with a Single Camera InstallationConnecting with a Multiplexer Basic ConnectionClock SET Connecting with a QuadAttaching AN External Device to DVR System Information Hard-Disk Drive InstallationIDE Quality Best Ntsc Rate 6 HRBasic Operations Configuring Recording SettingsUpdating System Software Ntsc MUX onPAL MUX OFF Audio OFFPAL MUX on Manual Recording Timer RecordingRecording Operations Externally triggered Recording Alarm RecordingREC Stop Play Playback OperationsFast Forward/Reverse Slow Forward/Reverse Search OperationsPlay Back Recorded Video from a HDD of the mobile rack Full List SearchTime Search Alarm list SearchThumbnail Search SD Card Search Backup OperationsMobile Rack HD Backup Alarm Select Main Backup Alarm to HD2 Secure Digital Card SD Card BackupDisk Setting Reformat HD2 Usage Save to J0000.JPGTransfer the system setting info of DVR to another Menu SetupKey Lock Operation KEY FunctionsAlarm Setting REC SettingPRE- Alarm OFF Main Alarm REC Enable REC Quality REC Quality Best Disk FullPRE- Alarm NET Enable OFF NET Dhcp NET IP SET FTP Setting Main Clock / TimerNET Enable CommunicationEnable Comm Setting FTP Setting Comm IDREC Mode Alarm REC REC ModeHD 1 Disk Setting SystemMain Menu Record Disk Setting Bios Menu Backgnd SD Setup MAC DateRS-232 & RS-485 Protocol SetupCommunication Protocol DEC HEXMobile Rack Installation Page SET RS232 / RS485 System DefaultNetwork Viewer and Image Viewer S.D MessageD Message Meanings Network ViewerView the VR-601 video from a remote PC CancelURL of a Proxy PortFunction Buttons Description Viewing images View all the connected devicesView single device Set the regular record settings Change the Record & Timer Properties Via the NetworkSet the Alarm record settings Set the record timerArchive Images to the Computer Image ViewerIndex Table Network ConfigurationEnable Dhcp Function RJ-45 PIN configuration for LAN HubConfigure Your DVR Network Settings Enable DVR Network Function12.3 TCP/IP Communication Software 12.5 TCP/IP Configuration setting 12.4 TCP/IP installationConnection Testing Click Start Æ Settings Æ Control Panel Æ NetworkModel Number VR-601 U VR-601 E SpecificationsDesign and specifications subject to change without notice Manufacturer Model Channel Compatible MultiplexersColors Decode onPrecautions