3. INSTALLATION
Please follow the instructions and the diagram below to set up the system.
3.1 Basic Connection
CONNECTIONG TO THE AC ADAPTER
Connect the provided AC adapter to the main unit.
|
|
|
|
| Screw |
|
|
| SD Card |
| Clamp |
| FROM MUX |
|
|
| |
VIDEO | MAIN MONITOR |
|
|
| |
|
| AUDIO |
|
| |
| IN | IN |
|
|
|
|
| ETHERNET |
|
| |
|
| 10/100 |
|
|
|
|
| OUT |
|
|
|
| OUT |
|
|
|
|
TO | TO |
| ALARM | I/O | DC12V |
MUX'S VCR IN | MONITOR |
|
AC | DC IN terminal | |
DC cord | ||
|
Provided AC
mains cable Provided AC adapter
1.Connect the DC cord of the AC adapter to the DC IN terminal of the main unit.
2.To prevent accidental disconnection of the DC cord, fasten the DC cord with a wire catch.
1)Remove 1 screw followed by the wire catch.
2)Insert the DC cord into the wire catch and fasten the wire catch unto the main unit.
3.Connect the provided power cord to the AC IN terminal of the AC adapter.
4.Connect the power cord to the power socket.
•Power is channeled into the unit and the OPERATE indicator lights up green. (OPERATE ON mode)
•Press OPERATE button 
for at least 3 seconds to power off and the OPERATE indicator lights up orange. (OPERATE OFF mode)
The orange light signals the
Memo
•Even in the OPERATE OFF mode, a small amount of electricity will still flow into the unit.
•When the unit is in the OPERATE OFF mode, no operation can be performed except that of the OPERATE button.
•It might show an error message "DATA ERROR" and stop recording when the condition of main power is not stable. When this is assumed, please use an uninterruptible power supply (UPS). When an error message is displayed, please reboot the
*About the location of the buttons, please refer to Page 10 2.1 Front View.
Note:
•Please supply power to the unit via the provided AC adapter. Do not use other power sources.
•During recording or playback, please do not unplug the DC or power cord.
CONNECTING WITH A SINGLE CAMERA
Please set the MULTIPLEXER option to OFF on the REC SETTING page in the setup menu when it is connected with a single camera. (Please refer to section 5.1 MULTIPLEXER option)
Camera |
|
|
|
| |
|
|
| SD Card |
|
|
VIDEO | FROM MUX |
|
|
|
|
MAIN MONITOR |
|
|
|
| |
|
| AUDIO |
|
| |
|
|
|
|
| |
| IN | IN |
|
|
|
|
| ETHERNET |
|
| |
|
| 10/100 |
|
|
|
OUT | OUT |
|
|
| |
|
|
|
| ||
TO | TO |
| ALARM | I/O | DC12V |
MUX'S VCR IN | MONITOR |
| |||
|
|
| |||
Monitor
CONNECTING WITH A MULTIPLEXER
To match the multiplexer’s recording speed, please set the MULTIPLEXER option to ON on the REC SETTING page in the setup menu when it is connected with a multiplexer. (Please refer to section 5.1 MULTIPLEXER option)
Caution: Some multiplexers may cause
14 | 15 |