NEC MA4000 manual Backbone Source, Backbone Destination, Setting up the backbone destination

Setting Up Infrastructures 4-21

Backbone Source

Setting up the backbone source

Step 1 Click the Source tab. The Connection Location box is populated with the selected source location.

Step 2 In the Connection Device Type box, click the appropriate radio button:

—Termination Hardware if this backbone starts on termination hardware.

—Splice Enclosure if the backbone starts at a splice.

—Asset if the backbone starts at an asset.

Step 3 Click Save.

Backbone Source

Step 1 Click the Source tab. The Connection Location Select group box is populated with the selected source location.

Step 2 The Connection Device Type frame contains radio buttons labeled Termination Hardware, Splice Enclosure, or Asset.

Step 3 Click the Termination Hardware button if this backbone starts on termination hardware.

Step 4 Click the Splice Enclosure button if the backbone starts at a splice.

Backbone Destination

The Destination tab functions similarly to the Source tab, except that the Connection Location Select information is not populated.

Setting up the backbone destination

Step 1 Click the Set Location button in the Detail area to open the Location window.

Step 2 Select the Destination from the tree. Building, Floor, and Space are populated, unless you are connecting from an outdoor space, such as a Utility Pole. In that case, only Space is populated.

Step 3 Click Accept.

Step 4 In the Connection Device Type box, click the appropriate radio button:

—Termination Hardware if this backbone ends on termination hardware.

—Splice Enclosure if the backbone ends at a splice.

—Asset if the backbone ends at an asset.

Step 5 Click Save.

MA4000 Expense Management Cable Management User Guide - Issue 1