Hitachi 32PD7800 Component Names Remote control, Loading Batteries, Handling the Remote Control

Page 10

COMPONENT NAMES (continued)

Remote control

POWER ON/OFF button

INPUT SELECT buttons

MENU button

OK button

SOUND MODE button

VOLUME UP/DOWN button

PROGRAM SELECT buttons (TV)

MULTI MODE button

T/TEXT button (TV)

RECALL button

FUNCTION SELECT button

DVD CONTROL button

FREEZE/RETURN buttons

SELECT/ADJUST button

PICTURE MODE button

CH I/CH II button (TV)

CHANNEL UP/DOWN button (TV) MUTE button

MULTI PICTURE button

PHOTO INPUT buttons

SWIVEL button

Loading Batteries

1.Open the battery cover.

Slide back and remove the battery cover in the direction of the arrow.

2.Load batteries.

Load two Size AA batteries included observing the correct polarities.

3.Close the battery cover.

Replace the battery cover in the direction of the arrow and snap it back into place.

Handling the Remote Control

Use the remote control within about 5 m from front of the unit’s remote-control sensor and within 30 degrees on both sides.

With in 30

With in 30 degrees degrees

About 3m

About 3m

About 5m

CAUTION

Do not use new and old batteries together. The batteries could explode or leak, resulting in fires, physical injury, or stains.

When loading batteries, observe their correct polarities as marked on the product. If loaded in the wrong direction, the batteries could explode or leak, resulting in fires, physical injury, or stains.

ATTENTION

Do not drop or impact the remote control.

Do not splash the remote control with water or put it on a wet object to avoid possible failures.

Before leaving the remote control out of use for an extended period of time, remove the batteries from it.

If the remote control begins to lack responsiveness, replace the batteries.

Strong light such as direct sunlight impinging on the photoreceptor of the remote control can cause operational failure. Position this unit to avoid direct contact with such light.

10

Image 10
Contents 32PD7800 42PD7800 Features Contents Safety Instructions About the SymbolsBe sure to keep safety ground connection Safety Instructions About the SymbolsBe cautious of the power cord connection Be careful in handling the battery of the remote controlBe careful in operating power swivel Avoid a high temperature environmentRemove the power cord for complete separation Installation environmentDo not physically impact the remote control Precautions for the cable connectionPrecaution during transportation Set the sound volume at a suitable levelImage Retention of Plasma Display Component Names Main UnitHandling the Remote Control Component Names Remote controlLoading Batteries DVD and SAT Recall Video/RGB Photo Input 37/42 onlyUP / Down button Color buttons Button for Teletext ModeSUB Title button Reveal button Anti-tumble measures Installation InstructionsInstallation Securing to a wall or pillarAn example of connecting audio visual devices HdmiPrecautions when connecting the antenna RGB1 DVI-PC RGB2 RGB Installation Instructions Connecting to a PCDVI For details, refer toMounting the Speaker System to the Monitor Installation Instructions Mounting the Speaker UnitTreating the wire ends Mounting the Speaker System to the MonitorHow to connect Speaker Attach the speaker cables to speaker systemsWith the speaker unit Installation Instructions Mounting the Side InputWithout the speaker unit Installation Instructions Power Cord Connection Indicating lamp Turning Power On and OffOperating Instructions IndicatingDisplay size selection diagram Input SwitchingSize Switching Operating InstructionsUsing a wide-screen monitor Operating Instructions Size Switching continudeDisplay area selection diagram RGB input During RGB Input RGB1 set to DVI-PC and RGB2 set to RGBAdjustment status guide display Operating Instructions Volume AdjustmentVolume setting value Audio MuteAdjust for preferred angle Operating Instructions Power SwivelPress Swivel button Operating Instructions Input Signal Screen Display Displaying Multi Picture SELECT/ADJUSTMulti Mode Multi Picture Pictures Split 4 pictures 12 picturesPictures Split Operating Instructions Displaying Multi PicturePictures Freeze button Picture FreezingSplit Strobe Photo Input Display 37/42 only Operating the Photo InputOperating Instructions Photo Input Display 37/42 only SpecificationError Information Photo Input FunctionOperating Instructions Photo Input Display 37/42 only Menu button OK button Recall button Return button Using the Menu Screen On-screen display systemButtons Operating Instructions Setup Menu TV mode MenuSelected characters Setup hint PAL SecamOperating Instructions Setup Menu Video mode Off 1280x768 1366x768 RGB1 DVI-PCMovie Function Menu Operating Instructions Picture Menu TV/Video mode Contrast Mode Picture ModeColor Temperature ResetCyan Color ManagementMagenta Color DecodingPicture Enhancement Audio Menu Language Menu Timer MenuHours Minutes Automatic Store Other FunctionsMenu Display Registration condition Bilingual / Dual sound broadcast Other Functions Audio SwitchingA2 / Nicam / Sound Multiplex TV mode Stereo sound broadcastOther Functions Power Save Mode DVD Player/STB SelectionOther Functions DVD Player/STB Selection Signal Check RGB modeSet up hint Status Display ActionSymptoms That Seemingly Appear to be Failures TroubleshootingSymptom Point to check English Troubleshooting Actions to Correct Abnormal Displays ExampleProduct Specifications DisplayInput connector pin specifications Product Specifications Signal InputRGB terminal D-sub 15-pin connector Photo-input connector pin specificationsWith component input AV1, AV2 and RGB2-component input Product Specifications Recommended Signal ListApplicable video signals for input terminal TV mode With Hdmi input AV6 inputKHz MHz With Digital signal input640 400 70.08 31.47 25.18 480 59.94 With Analog signal input RGB2 input Screw