Hitachi 32PD7800, 42PD7800 user manual Operating Instructions Setup Menu Video mode

OPERATING INSTRUCTIONS (continued)

SETUP MENU (Video mode)

MENU

Picture

Audio

Timer

Function

Setup

Language

Select

OK Set

Setup			Setup
	System	System 1		Color System
	Color System
	Video Input			AV1	Auto
	RGB1	DVI-STB		AV2	PAL
	RGB2	Component		AV3	SECAM
		HDTV		AV4	PAL
				AV5	Auto
	Select OK Set	Return		Select	Return	Exit

Setup			Setup
	System	System 1		Video Input
	Color System
	Video Input			AV1	Auto
	RGB1	DVI-STB		AV2	Auto
	RGB2	Component
		HDTV
	Select OK Set	Return		Select	Return	Exit

Selected characters										Setup hint
System			System1					System2		Do not change the original setting.
										(System1 : Europe/Asia, System2 : North America)
Color System
	System1									This should correspond to the color system of the signal from the equip-
		Auto			PAL				SECAM	ment that is connected to AV1~AV5 video input terminal.
										• Normally, set this to Auto. The system of the input signal will be auto-
		NTSC3.58						NTSC4.43
AV1~AV5										matically recognized.
	System2									• If the input signal contains much noise or has a low level at Auto and
										the operation is found erratic, set this to match the input signal.
		Auto			NTSC-M
										• When the component signal is received, this would be not available
		PAL-N				PAL-M				(grayed out).
Video Input
										This should correspond to the signal mode of the signal from the equip-
										ment that is connected to AV1, 2 video input terminal.
AV1, AV2	Auto			HDTV					SDTV/DVD	• Normally, set this to Auto. The signal mode of the input signal will be
										automatically recognized.
										• If the input signal contains much noise or has a low level at Auto and
										the operation is found erratic, set this to match the input signal.
RGB1			DVI-PC					DVI-STB		This should correspond to the signal mode of the signal from the equip-
										ment that is connected to RGB1 DVI terminal.
RGB2 (1st step)			RGB				Component			This should correspond to the signal mode of the signal from the equip-
										ment that is connected to RGB2 D-sub terminal.
										This step should be set only when [Component] is selected on the 1st
										step.
										This should correspond to the signal mode of the signal from the equip-
RGB2 (2nd step)	Auto			HDTV					SDTV/DVD	ment that is connected to RGB2 D-sub terminal.
										• Normally, set this to Auto. The signal mode of the input signal will be
										automatically recognized.
										• If the input signal contains much noise or has a low level at Auto and
										the operation is found erratic, set this to match the input signal.

36