INSTALLATION INSTRUCTIONS (continued)
Mounting the Speaker Unit
CAUTION
Make sure that the main power swich of the monitor is turned off (standby or indicating lamp: off/red) when removing or connecting the speaker cables.
Mounting the Speaker System to the Monitor
1. Mounting the Speaker System to the Monitor | Right Side |
|
Hook the clamps (3 pieces) into the holes as shown in the figure, and pull them down.
Follow the step in both Right and Left sides.
Clamps
CAUTION
Make sure to use the speaker systems fastened with the speaker holders and the screws.
Rear of the monitor
2.Attach the speaker holders
After twisting the screws off as shown, fasten the speaker system to the monitor with the speaker holder by the screws. The speaker holder direction is opposite on the Right and Left speaker systems.
Right Side | Monitor |
|
| |
Speaker | NOTE |
| ||
|
| |||
| System |
| ||
| Speaker holder | In case that the speaker |
| |
|
| systems do not fit with |
| |
|
| the monitor body’s |
| |
|
| height. |
| |
| Screws x 4 | When loosen the screws | Aluminum pieces | |
Twist off | fixing the aluminum pieces, | |||
Speaker holder |
| |||
the screws | the speaker system is |
| ||
|
| |||
|
| movable up and down. | Screwdriver | |
|
| Adjust the position to the |
| |
Rear of the monitor |
| monitor body’s height, then |
| |
| tighten up the screws. |
| ||
| Screws x 4 |
| ||
|
|
|
Place to attach the side input.
3. Attach the speaker connecting cables to the monitor. (Make sure the ferrite core is toward the monitor side)
ENGLISH
Treating the wire ends
Pull off while twisting
Please prepare the supplieol speaker cables
(R) | (L) | ||
Black | Red | Black | Red |
Connect the | Connect the | Connect the | Connect the |
silver | copper | silver | copper |
colored wire | colored wire | colored wire | colored wire |
Ferrite core |
|
| Ferrite core | |
How to connect | Press down | Insert the wire | Raise | |
the speaker | ||||
the lever |
| the lever | ||
cables |
| |||
|
|
| ||
(Moniter side) |
|
|
|
17