Hitachi 42PD7800, 32PD7800 Operating Instructions, Turning Power On and Off, Indicating lamp

48 49 50

OPERATING INSTRUCTIONS

Indicating lamp

Main power switch

(32)

(37)

(42)

SUB-POWER button

POWER ON/OFF button

Turning Power On and Off

•To turn the monitor power ON, press the main power switch on the monitor main unit to ON, and then press the SUB POWER button of control panel or the power button on the remote control.

•To turn the monitor power OFF, press the SUB POWER button of control panel or the power button on the remote control, and then press the main power switch on the monitor main unit to OFF.

•During normal use, the main power switch is set in the ON position, and the monitor can then be turned ON/OFF using the SUB POWER button or the power button on the remote control.

Indicating lamp

Indicating	Power status	Operating
lamp
Off	Off	When the main power switch is set to
		OFF.
		When the main power switch is ON, and
	Off	the power button on the remote control
Lights red		or the SUB POWER button on the
	(standby)
		underside of the front of the frame is
		OFF.
		When the main power switch is ON, and
		the power button on the remote control
Lights green	On	or the SUB POWER button on the
		underside of the front of the frame is
		ON.
		When the main power switch is ON, and
		the power button on the remote control
	Off	or the SUB POWER button on the
Lights orange		underside of the front of the frame is
	(Power Save)
		ON.
		However, the state in POWER SAVE
		mode

When the indicating lamp lights in orange or the message “No Sync. Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen, there is something unusual about the status of reception. See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.”

ATTENTION

•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.

•Turn off the main power switch before leaving the monitor out of use for an extended period of time.

•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.

ENGLISH

21