Hitachi 42PD7800 Other Functions DVD Player/STB Selection, Signal Check RGB mode, Set up hint

OTHER FUNCTIONS (continued)

DVD Player/STB Selection (continued)

Set up hint

Example) HITACHI DVD

To operate HITACHI DVD player, press and hold the button, followed by the button.

1.Press button to indicate the lamp of DVD on the remote control.

During LED lighting, press	and to set up the maker.
2. Release the button once while keeping		button, press
the button again to set the maker type.

*After set up the maker type, press the button related with DVD, and make sure that DVD player is working. In case DVD player does not work, repeat 1 and 2 with other numbers for the maker type to make sure it. (In this example, press or .)

NOTE

•Not all models of the listed makers can be operated using this remote control.

ENGLISH

Signal Check (RGB mode)

Changes in the signal status are displayed on the screen as they arise.

Status	Display		Action
When Mode Display is set to ON,	A guide is displayed for the input
the input signal is switched or	terminal and the horizontal and
when the RECALL button is	vertical sync frequency.
pressed.
When the sync signal is no	• A guide displays No Sync.	Recheck the personal computer
longer detected.	Signal, and Power Save (for	power switch status and the
	approx. 5 sec.)	connection status.
	• When the condition continues
	where the sync signal cannot
	be detected, indicator lamp of
	power source changes in
	orange and the mode switches
	to power save mode.
When the input signal does not	A guide displays Invalid Scan	Recheck the input signal
match the monitor specifications	Freq.	specifications.
or is in an unstable status.		54 ~ 57

RGB

RGB2

RGB

H : 48.4kHz

V : 60.1 Hz

OFF -- -- Min.

-- -- : -- --

! No Sync. Signal

! Invalid Scan Freq.

49