Alarm Type Description — Decoder
Alarm Type | Description | Action | Default Settings |
|
|
|
|
|
|
|
|
No decoder video | Indicates that there is a valid |
| Warning, reporting |
data | connection, no video data |
|
|
| present. Usually accompanied by |
|
|
| "no source data stream" message |
|
|
| in the web interface. |
|
|
|
|
|
|
No decoder mode | No matching decoder mode for |
| Warning, reporting |
| the incoming stream. |
|
|
|
|
|
|
No source report | Unable to detect the format of |
| Warning, reporting |
| the received data stream. |
|
|
Recovered audio |
|
| Warning, reporting |
|
|
|
|
No decoder audio |
|
| Warning, reporting |
data |
|
|
|
|
|
|
|
Bad audio at decoder |
|
| Warning, reporting |
Bad audio PLL |
|
| Warning, reporting |
|
|
|
|
Video network | Excessive network packet loss has |
| Warning, reporting |
packets dropped | occurred. |
|
|
|
|
|
|
Decoder buffer | The incoming data rate is high; |
| Warning, reporting |
overflow | reduce the pipeline delay. |
|
|
Decoder buffer | The incoming data rate is too low; |
| Warning, reporting |
underflow | increase the pipeline delay. |
|
|
|
|
|
|
Bad video PLL | The decoder cannot synchronize |
| Warning, reporting |
| to the video data. |
|
|
|
|
|
|
No decoder ANC data | The decoder is not receiving any |
| Warning, reporting |
| embedded audio (ancillary) data. |
|
|
Missing ANC at | The Decoder is receiving poor |
| Warning, reporting |
decoder | quality ANC data. |
|
|
|
|
|
|
Recovered ANC | Error correction has recovered |
| Warning, reporting |
| corrupted / missing ANC. |
|
|
|
|
|
|
No genlock source | Indicates that genlock is enabled, | Connect a valid genlock | Warning, reporting |
present | but that there is no genlock | signal. |
|
| source connected. |
|
|
No genlock source | Indicates that a signal is present | Check the format of the | Warning, reporting |
lock | on the genlock connector, but it is | genlock signal. |
|
| not within the expected range. |
|
|
|
|
|
|
Genlock source | Indicates that the timing of the | Connect a valid genlock | Warning, reporting |
mismatch | genlock signal does not match the | signal. |
|
| format of the decoded source. |
|
|
Alarm Type Description — System Controller
Alarm Type | Description | Action | Default Settings |
|
|
|
|
Bad device | The controller is unable to contact | Check the device in question. | Critical, reporting |
| the specified device. The device is | Is power applied? |
|
| not available or has failed. | Is the network cable or |
|
| Note that this alarm is only | network connection present? |
|
| generated on the controller. | Has the unit been removed? |
|
|
|
|
|
VNM Recorder • About Alarms | 61 |